LX1995-2SE EVAL KIT MICROSEMI, LX1995-2SE EVAL KIT Datasheet - Page 6

• Manufacturer Part Number: LX1995-2SE EVAL KIT
• Manufacturer: MICROSEMI

Specifications of LX1995-2SE EVAL KIT

• Lead Free Status / RoHS Status: Supplier Unconfirmed

LX1995
C
The LX1995 Evaluation Board has 9 test lead
attachment point for applying power and dimming
inputs or for monitoring voltages.
Copyright © 2004
Rev. 1.0, 2004-08-13
ONNECTIONS
Hints: For best results, use only one of the three possible LED dimming methods at a time. LED current can be monitored
by measuring the voltage from LED4 cathode to GND and dividing by 15 (the value of R4).
NOTE: Jumper JU1 must be connected for the LX1995 to function. This jumper can be replaced with a wire loop so the
inductor current waveform can be observed using a current probe.
Input Power
Power Ground
Enable
DC dimming
PWM dimming
Output Voltage
Signal Ground
Function
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: [phone]
Board Label
PWM_ADJ
DC_ADJ
/SHDN
VOUT
GND#
GND
VIN
Table 3 – Connection Points
Integrated Products
Microsemi
Power supply (3.55V+/- 1.95V).
Common power supply ground.
Connect to GND to disable LX1995. A <1KHz logic PWM signal
can also be applied.
Apply a 0 to 3V DC dimming input
Apply a >5KHz 3.3V logic PWM signal.
Test point to monitor voltage across all LEDs.
Multiple common grounds for probes. etc
Connection
E
VALUATION
G
Page 6
UIDE