ADM3202ARUZ-REEL7 Analog Devices Inc, ADM3202ARUZ-REEL7 Datasheet - Page 9

• Manufacturer Part Number: ADM3202ARUZ-REEL7
• Description: Dual Transmitter/Receiver RS-232 16-Pin TSSOP T/R
• Manufacturer: Analog Devices Inc
• Type: Transceiverr

Specifications of ADM3202ARUZ-REEL7

• Package: 16TSSOP
• Data Transmission Topology: Point-to-Point
• Interface Standards: EIA/TIA-232-E|RS-232|V.28
• Data Rate: 0.46(Min) Mbps
• Function: Line Transmitter/Receiver
• Number Of Transmitters: 2
• Transmitter Signal Type: Single-Ended
• Transmitter Communication Type: RS-232
• Typical Single Supply Voltage: 3.3 V
• Package / Case: 16-TSSOP
• Mounting Type: Surface Mount
• Voltage - Supply: 3 V ~ 5.5 V
• Number Of Drivers/receivers: 2/2
• Protocol: RS232
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Transmitter (Driver) Section
The drivers convert 3.3 V logic input levels into RS-232 output
levels. With V
voltage swing is typically ±6 V.
Receiver Section
The receivers are inverting level-shifters that accept RS-232
input levels and translate them into 3 V logic output levels. The
inputs have internal 5 kΩ, pull-down resistors to ground and are
protected against overvoltages up to ±30 V. Unconnected inputs
are pulled to 0 V by the internal 5 kΩ, pull-down resistor. This
results in a Logic 1 output level for unconnected inputs or for
inputs connected to GND.
The receivers have Schmitt-trigger inputs with a hysteresis level
of 0.4 V. This ensures error-free reception for both noisy inputs
and for inputs with slow transition times.
CC
= 3.3 V and driving an RS-232 load, the output
Rev. D | Page 9 of 12
HIGH BAUD RATE
The ADM3202/ADM3222 feature high slew rates permitting
data transmission at rates well in excess of the EIA/RS-232E
specifications. RS-232 voltage levels are maintained at data rates
up to 460 kbps even under worst-case loading conditions. This
allows high speed data links between two terminals and is
suitable for the new generation ISDN modem standards that
require data rates of 230 kbps. The slew rate is internally
controlled to less than 30 V/μs to minimize EMI interference.
ADM3202/ADM3222/ADM1385