90800-2 TE Connectivity, 90800-2 Datasheet - Page 5

• Manufacturer Part Number: 90800-2
• Description: Connector Accessories Crimp Die Set
• Manufacturer: TE Connectivity
• Type: Die Setr

Specifications of 90800-2

• Wire Size (awg): 28-22
• Rohs Compliant: NA
• Lead Free Status / RoHS Status: RoHS Not Applicable
• For Use With: SDE Crimp Hand Tool
• Lead Free Status / Rohs Status: RoHS Exempt Product

8. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
9. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimp sections for flattened,
Rev B
PRO-CRIMPER III Hand Tool Assembly and Die Assembly
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel COUNTERCLOCKWISE to a
higher–numbered setting. If a looser crimp is
required, rotate the adjustment wheel
CLOCKWISE to a lower–numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
Tyco Electronics Corporation
chipped, worn, or broken areas. If damage or
abnormal wear is evident, the tool must be replaced.
See Section 10, REPLACEMENT.
10. REPLACEMENT
Customer–replaceable parts are shown in Figure 1.
Available separately, PRO–CRIMPER III Tool Repair
Kit 679221–1 includes a replacement nut and a
variety of pins, rings, screws, and springs. If the dies
are damaged or worn excessively, they must be
replaced. Order the repair kit and replaceable parts
through your Tyco Electronics representative, or call
1–800–526–5142, or send a facsimile of your
purchase order to 1–717–986–7605, or write to:
11. REVISION SUMMARY
Since the previous release of this sheet, the following
changes were made:
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
Updated document to corporate requirements
Changed contact information for obtaining
crimp height comparator in Section 6.
08- 007
5 of 5