5536513-2 TE Connectivity, 5536513-2 Datasheet - Page 6
![Conn Hard Metric HDR 48 POS 2mm Press Fit ST Thru-Hole](/photos/37/42/374260/pr4rwsigvrtpin_sml.jpg)
5536513-2
Manufacturer Part Number
5536513-2
Description
Conn Hard Metric HDR 48 POS 2mm Press Fit ST Thru-Hole
Manufacturer
TE Connectivity
Type
Hard Metricr
Series
5536513r
Specifications of 5536513-2
Pitch
2 mm
Number Of Rows
4
Number Of Contacts
48
Termination Method
Press Fit
Mounting
Through Hole
Contact Plating
Gold Over Nickel
Product Type
Connector
Connector Type
Header
Pcb Mounting Orientation
Vertical
Post Type
Solder Post
Module Type
Signal
Mating Post Length (mm [in])
5.00 [0.197]
Pin Header Width (mm [in])
16.00 [0.622]
Voltage Rating (vac)
30
Termination Post Length (mm [in])
4.25 [0.167]
Number Of Signal Positions
48
Sequencing
No
Post Plating
Tin
Centerline, Matrix (mm [in])
2.00 x 2.00 [.079 x .079]
Contact Type
Pin
Contact Base Material
Phosphor Bronze
Contact Plating, Mating Area, Material
Gold (30)
Connector Style
Plug
Housing Material
Liquid Crystal Polymer (LCP)
Rohs/elv Compliance
RoHS compliant, ELV compliant
Lead Free Solder Processes
Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C, Reflow solder capable to 245°C, Reflow solder capable to 260°C, Pin-in-Paste capable to 245°C, Pin-in-Paste capable to 260°C
Rohs/elv Compliance History
Always was RoHS compliant
Applies To
Printed Circuit Board
Application
Fixed-Board
Lead Free Status / Rohs Status
Details
4.2.
4.3.
4.4.
Rev C
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets requirements of Figure 1. Failures attributed
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted for qualification. Testing to confirm
corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
2.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 3.
Power connectors.
Power connector housings and contacts shall be prepared in accordance with applicable
Instruction Sheets and shall be selected at random from current production. All test groups
shall consist of 5 connectors each of the largest available size. All tests requiring individual
contact measurements shall be conducted on 30 contacts randomly selected over the 5
connectors. Test groups 1 and 2 shall be mounted on printed circuit boards designed to
accommodate vibration and physical shock fixturing providing a series circuit for all contacts
with access to measure termination resistance.
Contact Resistance Measurement Points
Figure 4
108-1441
6 of 8