HEDS-9141#A00 Avago Technologies US Inc., HEDS-9141#A00 Datasheet - Page 8
![Encoders 3 Channel 500CPR](/photos/16/35/163584/hedl-9100aoo_wht_sml.jpg)
HEDS-9141#A00
Manufacturer Part Number
HEDS-9141#A00
Description
Encoders 3 Channel 500CPR
Manufacturer
Avago Technologies US Inc.
Datasheet
1.HEDS-9141A00.pdf
(13 pages)
Specifications of HEDS-9141#A00
Number Of Channels
3
Mounting Style
PCB
Supply Voltage
5 V
Product
Optical
Technology
Rotary
Pulses Per Revolution
500 CPR
Termination Style
Solder Pin
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Mounting with an Alignment Tool
The HEDS-8905 and HEDS-8906 alignment tools are rec-
ommended for mounting the modules with Side B as the
mounting plane. The HEDS-8905 is used to mount the
HEDS-9140, and the HEDS-8906 is used to mount the
HEDS-9040. These tools fix the module position using
the codewheel hub as a reference. They will not work if
Side A is used as the mounting plane.
The following assembly procedure uses the HEDS-
8905/8906 alignment tool to mount a HEDS-9140/9040
module and a HEDS-5140/6140 codewheel:
Instructions:
1. Place codewheel on shaft.
2. Set codewheel height by placing alignment tool
3. Insert mounting screws through module and thread
4. Slide alignment tool over codewheel hub and onto
5. While holding alignment tool in place, tighten screws
6. Remove alignment tool.
Mounting with Aligning Pins
The HEDS-9040 and HEDS-9140 can also be mounted us-
ing aligning pins on the motor base. (Hewlett-Packard
does not provide aligning pins.) For this configuration,
Side A must be used as the mounting plane. The align-
ing recess centers must be located within the 0.005 in. R
Tolerance Circle as explained above. Figure 5 shows the
necessary dimensions.
8
on motor base (pins facing up) flush up against the
codewheel as shown in Figure 3. Tighten codewheel
setscrew and remove alignment tool.
into the motor base. Do not tighten screws.
module as shown in Figure 4. T he pins of the alignment
tool should fit snugly inside the alignment recesses of
the module.
down to secure module.
Figure 3. Alignment Tool is Used to Set Height of Codewheel.
Figure 4. Alignment Tool is Placed over Shaft and onto Codewheel Hub.
Alignment Tool Pins Mate with Aligning Recesses on Module.