MCP73832T-4ADI/OT Microchip Technology, MCP73832T-4ADI/OT Datasheet - Page 11

• Manufacturer Part Number: MCP73832T-4ADI/OT
• Description: IC,Battery Management,TSOP,5PIN,PLASTIC
• Manufacturer: Microchip Technology

Specifications of MCP73832T-4ADI/OT

• Function: Charge Management
• Battery Type: Lithium-Ion (Li-Ion), Lithium-Polymer (Li-Pol)
• Voltage - Supply: 3.75 V ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: SC-74A, SOT-753
• Product: Charge Management
• Output Voltage: 4.4 V
• Output Current: 15 mA to 500 mA
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: TC110DM - BOARD EVAL BATT CHARGER TC110
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

3.0
The descriptions of the pins are listed in
TABLE 3-1:
3.1
A supply voltage of [V
recommended. Bypass to V
4.7 µF.
3.2
Connect to positive terminal of battery. Drain terminal
of internal P-channel MOSFET pass transistor. Bypass
to V
when the battery is disconnected.
3.3
STAT is an output for connection to an LED for charge
status indication. Alternatively, a pull-up resistor can be
applied for interfacing to a host microcontroller.
STAT is a tri-state logic output on the MCP73831 and
an open-drain output on the MCP73832.
© 2008 Microchip Technology Inc.
DFN
SS
1
2
3
4
5
6
7
8
9
with a minimum of 4.7 µF to ensure loop stability
Pin No.
PIN DESCRIPTION
Battery Management Input Supply
(V
Battery Charge Control Output
(V
Charge Status Output (STAT)
DD
BAT
SOT-23-5
)
)
—
—
—
—
4
3
1
2
5
PIN FUNCTION TABLES
REG
(typical) + 0.3V] to 6V is
Symbol
SS
PROG
STAT
V
V
V
V
V
NC
EP
BAT
BAT
DD
DD
SS
with a minimum of
Table
Battery Management Input Supply
Battery Management Input Supply
Battery Charge Control Output
Battery Charge Control Output
Charge Status Output
Battery Management 0V Reference
No Connection
Current Regulation Set and Charge Control Enable
Exposed Thermal Pad (EP); must be connected to V
3-1.
3.4
Connect to negative terminal of battery and input
supply.
3.5
Preconditioning, fast charge and termination currents
are scaled by placing a resistor from PROG to V
The charge management controller can be disabled by
allowing the PROG input to float.
3.6
There is an internal electrical connection between the
Exposed Thermal Pad (EP) and the V
be connected to the same potential on the Printed
Circuit Board (PCB).
Vias are recommended to add from land area of EP to
a copper layer on the other side of the PCB for better
thermal performance.
Battery Management 0V Reference
(V
Current Regulation Set (PROG)
Exposed Thermal Pad (EP)
SS
Function
)
MCP73831/2
SS
.
DS21984E-page 11
SS
pin; they must
SS
.