SST39VF400A-70-4C-MAQE-T Microchip Technology, SST39VF400A-70-4C-MAQE-T Datasheet
SST39VF400A-70-4C-MAQE-T
Specifications of SST39VF400A-70-4C-MAQE-T
Available stocks
Related parts for SST39VF400A-70-4C-MAQE-T
SST39VF400A-70-4C-MAQE-T Summary of contents
Page 1
Designing In SST’s Multi-Purpose Flash (39 Series) Byte-wide Products Designing In SST’s Multi-Purpose Flash (39 Series) Byte-wide Products INTRODUCTION This application note introduces the SST 39 series - SST’s mainstream Multi-Purpose Flash (MPF) product line. It describes how to convert ...
Page 2
Application Note SST AND AMD Comparisons with the AMD Am29F series AMD’s Am29F series includes 1M, 2M, and 4M devices; the Am29F010, Am29F002(N), respectively. AMD also has 1M, 2M, and 4M devices in the Am29LV series - Am29LV010, Am29LV002, and ...
Page 3
Designing In SST’s Multi-Purpose Flash (39 Series) Byte-wide Products The primary difference is Sector-Erase operation which is described here: the Sector-Erase operation for both SST39 and AMD devices use the same six-byte command sequence with the same command data of ...
Page 4
Application Note In summary, an SST39VF016 can be used on existing Am29LV017D-based design without any board layout changes when used in x16 mode. Software Comparisons The SST39VF016 uses the standard JEDEC command set for single-power-supply flash Am29LV017D only uses JEDEC-compatible ...
Page 5
Designing In SST’s Multi-Purpose Flash (39 Series) Byte-wide Products therefore substitute it without any board layout modifica- tions. A system design which currently uses ST Micro’s 8mm x 20mm package can use SST’s 8mm x 14mm pack- age if a ...
Page 6
Application Note not erased. An alternative is to erase the entire chip, and then re-program the corresponding to the ST Micro boot-block. • The M29F010 is based on uniform sector architecture of 16 KByte each, as opposed to 4 KByte ...
Page 7
Designing In SST’s Multi-Purpose Flash (39 Series) Byte-wide Products Software Comparisons The SST39VF016 uses the standard JEDEC command set for x16 single-power-supply flash memory while the M29W017D only uses JEDEC-compatible command sets. The command sequences for basic device operations between ...
Page 8
Application Note Software Comparisons The SST 39 series and AT49 series devices use the same command set for Byte-Program, Chip-Erase, Read-ID, and Reset operation as described in the table below. TABLE 11 OMMAND EQUENCE Command SST Byte-Program 4-Byte ...
Page 9
Designing In SST’s Multi-Purpose Flash (39 Series) Byte-wide Products TABLE 13 OMMAND ET OMPARISON SST Word-Program 4 Cycle with A0H Sector-Erase 6 Cycle with 30H Block-Erase 6 Cycle with 50H Chip-Erase 6 Cycle with 10H ID Entry ...
Page 10
Application Note ©2005 Silicon Storage Technology, Inc. Multi-Purpose Flash (39 Series) Byte-wide Products 10 Designing In SST’s S72014-04-000 10/05 ...