USB3326C-GL-TR Standard Microsystems (SMSC), USB3326C-GL-TR Datasheet - Page 3

• Manufacturer Part Number: USB3326C-GL-TR
• Manufacturer: Standard Microsystems (SMSC)

Specifications of USB3326C-GL-TR

• Number Of Transceivers: 1
• Esd Protection: YeskV
• Power Supply Requirement: Single
• Operating Temperature Classification: Industrial
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Mounting: Surface Mount
• Operating Temperature (max): 85C
• Operating Temperature (min): -40C
• Lead Free Status / RoHS Status: Compliant

Industry’s Smallest Hi-Speed USB Transceiver with 1.8V ULPI Interface
General Description
SMSC USB332x
VBUS
DM
DP
ID
SMSC’s USB332x is a family of Hi-Speed USB 2.0 Transceivers that provides a physical layer (PHY)
solution well-suited for portable electronic devices. Both commercial and industrial temperature
applications are supported.
Each model in the USB332x family may use a 60MHz reference clock, or the model-number specific
reference clock shown in Order Numbers on page 2.
Several advanced features make the USB332x the transceiver of choice by reducing both electrical
bill of material (eBOM) part count and printed circuit board (PCB) area. Outstanding ESD robustness
eliminates the need for external ESD protection devices in typical applications. The internal Over-
Voltage Protection circuit (OVP) protects the USB332x from voltages up to 30V. By using a reference
clock from the Link, the USB332x removes the cost of a dedicated crystal reference from the design.
And the integrated USB switch enables unique product features with a single USB port of connection.
The USB332x meets all of the electrical requirements to be used as a Hi-Speed USB Host, Device, or
an On-the-Go (OTG) transceiver. In addition to the supporting USB signaling, the USB332x also
provides USB UART mode and USB Audio mode.
USB332x uses the industry standard UTMI+ Low Pin Interface (ULPI) to connect the USB PHY to the
Link. ULPI uses a method of in-band signaling and status byte transfers between the Link and PHY to
facilitate a USB session with only 12 pins.
The USB332x uses SMSC’s “wrapper-less” technology to implement the ULPI interface. This “wrapper-
less” technology allows the PHY to achieve a low latency transmit and receive time. SMSC’s low
latency transceiver allows an existing UTMI Link to be reused by adding a UTMI to ULPI bridge. By
adding a bridge to the ASIC the existing and proven UTMI Link IP can be reused.
OVP
Figure 1 USB332x Block Diagram
Transceiver
PRODUCT PREVIEW
Hi-Speed
DP/DM
Switch
OTG
USB
USB
3
Integrated
Low Jitter
Registers
and State
REFCLK
Machine
ULPI
PLL
Management
Integrated
Interface
DATA[7:0]
Power
BIAS
ULPI
Revision 1.1 (03-31-10)
RBIAS
RESETB
VBAT
VDD33
VDD18
STP
NXT
DIR
CLKOUT