A8WD-2262 Omron, A8WD-2262 Datasheet - Page 3

• Manufacturer Part Number: A8WD-2262
• Description: Rocker Switch
• Manufacturer: Omron

Specifications of A8WD-2262

• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

A8W
Precautions
Do not wire the Switch or touch any terminal of the
Switch While power is being supplied. Doing so may
result in electric shock.
To increase the reliability of operation, test the Switch before
actual operation.
Be sure that there is an enough insulation distance between any
Switch terminal and metal part.
Mounting
Wiring
Environment for Storage and Use
• Turn OFF the power supply before mounting, removing or wiring
• Easy to mount by snap fitting.
• Do not use panels other than ones with the designated thickness
• Do not impose excessive force on the Switch at the time of
• When soldering terminals manually, perform soldering within
• Quick-connect Terminals (#250 t=0.8) are not in compliance
• Be sure that the wires are thick enough for the load (current) to
• The performance of the Switch may be affected if the Switch is
• Do not use the Switch in places with sulfide gas, corrosive gas,
• Do not use the Switch in places that are visibly dusty. Otherwise,
the Switch, or before performing maintenance inspections.
Failure to do so many result in electric shock.
and dimensions. Remove all burrs from the cutout before
installing the Switch. Otherwise, the Switch may malfunction.
panelmounting. Otherwise the Switch may be damaged or
deformed, and the Switch mechanism may malfunction as a
result.
4 s using a soldering iron (temperature at the tip of the soldering
iron: 360 °C max). Do not apply excessive force to the terminals
during soldering.
with IEC standards. Suitable for use as solder connection.
be applied.
used for switching micro loads. Test the Switch under the actual
operating conditions.
sea breeze, oil spray, or direct sunlight. Otherwise, the Switch
may malfunction.
the contacts may fail to operate correctly.
Pushing Position
Caution
Case Flange
Handling
Dust & waterproof construction
Though panel sealed (IP67) at front, be caution the following
points for actual use.
RoHS Compliant
The “RoHS Compliant” designation indicates that the listed models
do not contain the six hazardous substances covered by the
RoHS Directive.
Reference: The following standards are used to determine
compliance for the six substances.
• Do not drop the Switch. Otherwise, the Switch may malfunction.
• Do not impose excessive force on the Switch. Otherwise, the
• Use the Switch within the rated voltage and current ranges,
• Do not impose force to operating part from an angle, otherwise
• Do not use Sealed Switches while submersed in water or in
• Do not use Sealed Switches in places that are visibly dusty.
• The seal is changed depending on the processing accuracy
Switch may deform.
otherwise the Switch may have a shortened life expectancy,
radiate heat, burn out or malfunction.
the Switch may be damaged or deformed.
locations exposed to water.
Otherwise, the Switch may malfunction.
and the panel thickness, and it is in the panel the fear of the
invasion of water. Test the Switch under the actual operating
conditions.
Lead
Mercury
Cadmium
Hexavalent chromium : 1000 ppm max.
PBB
PBDE
: 1000 ppm max.
: 100 ppm max.
: 1000 ppm max.
: 1000 ppm max.
: 1000 ppm max.
A8W
3