AT88SC153-9ET-XX Atmel, AT88SC153-9ET-XX Datasheet - Page 9
![no-image](/images/manufacturer_photos/0/0/78/atmel_sml.jpg)
AT88SC153-9ET-XX
Manufacturer Part Number
AT88SC153-9ET-XX
Description
Manufacturer
Atmel
Datasheet
1.AT88SC153-9ET-XX.pdf
(24 pages)
Specifications of AT88SC153-9ET-XX
Operating Temperature (max)
70C
Operating Temperature (min)
0C
Package Type
M2 - E Module
Operating Temperature Classification
Commercial
Lead Free Status / RoHS Status
Supplier Unconfirmed
Password Verification
Authentication Protocol
1016D–SMEM–04/04
In the write lock configuration, only one byte of the page can be written at a time. Even if
several bytes are received, only the first byte will be taken into account by the device.
Compare the operation password presented with the stored one, and write a new bit in
the corresponding attempts counter for each wrong attempt. A valid attempt erases the
attempts counter and allows the operation to be carried out as long as the chip is
powered.
The current password is memorized and active until power is turned off, unless a new
password is presented or RST becomes active. Only one password is active at a time.
The AT88SC153 requires that the Verify Password command be transmitted twice in
sequence to successfully verify a write or read password. (This two-pass method of
password verification was implemented in the AT88SC153 to protect the device from
attacks on the password security system.) The first Verify Password command can be
considered an initialization command. It will write a new bit (“0”) in the corresponding
PAC. The data bits in this initialization command are ignored. The second Verify Pass-
w o rd c omm an d w ill co mp ar e th e 3- b yte pas s w o r d dat a p re se nt e d wi th the
corresponding password value stored in memory. If the comparison is valid, the PAC will
be cleared. A successful password verification will allow authorized operations to be
carried out as long as the chip is powered. The current password is memorized and
active until power is turned off, a new password is presented, or RST becomes active.
Only one password is active at a time. If a new user zone is selected that points to a dif-
ferent password set, the new password must be verified and the old password becomes
invalid.
The access to an user zone may be protected by an authentication protocol in addition
to password-dependent rights.
The authentication success is memorized and active as long as the chip is powered,
unless a new authentication is initialized or RST becomes active. If the new authentica-
tion request is not validated, the card has lost its previous authentication and it should
be presented again. Only the last request is memorized.
The authentication verification protocol requires the host to perform an Initialize Authen-
tication command, followed by a Verify Authentication command.
The password and authentication may be presented at any time and in any order. If the
trials limit has been reached, i.e., the 8 bits of the attempts counter have been written,
the password verification or authentication process will not be taken into account.
AT88SC153
9