5962-9206203MXA QP SEMICONDUCTOR, 5962-9206203MXA Datasheet - Page 3

• Manufacturer Part Number: 5962-9206203MXA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-9206203MXA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
(Copies of these documents are available online at
Standardization Document Order Desk, 700 Robins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
1.3 Absolute maximum ratings.
1.4 Recommended operating conditions.
3/
4/
5/
6/
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
DEPARTMENT OF DEFENSE SPECIFICATION
DEPARTMENT OF DEFENSE STANDARDS
DEPARTMENT OF DEFENSE HANDBOOKS
Supply voltage range (V
DC input voltage range ------------------------------------------------ -2.0 V dc to +7.0 V dc
Maximum power dissipation ----------------------------------------- 2.5 W
Lead temperature (soldering, 10 seconds) ----------------------- +260°C
Thermal resistance, junction-to-case (θ
Case outlines X, Y, and Z -------------------------------------------- See MIL-STD-1835
Junction temperature (T
Storage temperature range ----------------------------------------- -65°C to +150°C
Temperature under bias range -------------------------------------- -55°C to +125°C
Endurance ---------------------------------------------------------------- 25 erase/write cycles (minimum)
Data retention ----------------------------------------------------------- 10 years (minimum)
Supply voltage range (V
Ground voltage (GND) ------------------------------------------------ 0 V dc
Input high voltage (V
Input low voltage (V
Case operating temperature range (T
Input rise time (t
Input fall time (t
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
MIL-STD-883
MIL-STD-1835 -
MIL-HDBK-103 -
MIL-HDBK-780 -
Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
Minimum dc input voltage is -0.3 V. During transitions, inputs may undershoot to -2.0 V for periods less than 20 ns.
Must withstand the added P
Case temperatures are instant on.
maximum levels may degrade performance and affect reliability.
Maximum dc voltage on output pins is V
load conditions.
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
F
R
) ------------------------------------------------------- 100 ns maximum
) ------------------------------------------------------ 100 ns maximum
STANDARD
-
IL
IH
) ------------------------------------------------- 0.8 V dc maximum
Interface Standard Electronic Component Case Outlines.
Standard Microcircuit Drawings.
Test Method Standard Microcircuits.
List of Standard Microcircuit Drawings.
) ----------------------------------------------- 2.2 V dc minimum
CC
J
CC
) -------------------------------------------- +175°C
) ------------------------------------------- -2.0 V dc to +7.0 V dc
) ------------------------------------------ +4.5 V dc to +5.5 V dc
D
due to short circuit test (e.g., I
3/
C
) -------------------------- -55°C to +125°C
JC
):
CC
+ 0.3 V, which may overshoot to +7.0 V for periods less than 20 ns under no
http://assist.daps.dla.mil/quicksearch/
SC
).
SIZE
A
5/
REVISION LEVEL
6/
or
4/
http://assist.daps.dla.mil
B
SHEET
5962-92062
from the
3