RFM22B-868-S1 QUASAR, RFM22B-868-S1 Datasheet - Page 18

no-image

RFM22B-868-S1

Manufacturer Part Number
RFM22B-868-S1
Description
MODULE, TRANSCEIVER, 20DB,SMD,868MHZ
Manufacturer
QUASAR
Datasheet

Specifications of RFM22B-868-S1

Modulation Type
FSK, GFSK, OOK
Data Rate Max
256Kbps
Sensitivity
-121dBm
Supply Voltage Range
1.8V To 3.6V
Supply Current
85mA
Interface Type
SPI
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
R F M 2 2 B / 2 3 B
3.2.3. TX State
The TX state may be entered from any of the IDLE modes when the txon bit is set to 1 in "Register 07h. Operating
Mode and Function Control 1". A built-in sequencer takes care of all the actions required to transition between
states from enabling the crystal oscillator to ramping up the PA. The following sequence of events will occur
automatically when going from STANDBY mode to TX mode by setting the txon bit.
1. Enable the main digital LDO and the Analog LDOs.
2. Start up crystal oscillator and wait until ready (controlled byan internal timer).
3. Enable PLL.
4. Calibrate VCO (this action is skipped when the vcocal bit is “0”, default value is “1”).
5. Wait until PLL settles to required transmit frequency (controlled by an internal timer).
6. Activate power amplifier and wait until power ramping is completed (controlled by an internal timer).
7. Transmit packet.
Steps in this sequence may be eliminated depending on which IDLE mode the chip is configured to prior to setting
the txon bit. By default, the VCO and PLL are calibrated every time the PLL is enabled.
3.2.4. RX State
The RX state may be entered from any of the IDLE modes when the rxon bit is set to 1 in "Register 07h. Operating
Mode and Function Control 1". A built-in sequencer takes care of all the actions required to transition from one of
the IDLE modes to the RX state. The following sequence of events will occur automatically to get the chip into RX
mode when going from STANDBY mode to RX mode by setting the rxon bit:
1. Enable the main digital LDO and the Analog LDOs.
2. Start up crystal oscillator and wait until ready (controlled by an internal timer).
3. Enable PLL.
4. Calibrate VCO (this action is skipped when the vcocal bit is “0”, default value is “1”).
5. Wait until PLL settles to required receive frequency (controlled by an internal timer).
6. Enable receive circuits: LNA, mixers, and ADC.
7. Enable receive mode in the digital modem.
Depending on the configuration of the radio all or some of the following functions will be performed automatically by
the digital modem: AGC, AFC (optional), update status registers, bit synchronization, packet handling (optional)
including sync word, header check, and CRC.
3.2.5. Device Status
Add R/W Function/Description
D7
D6
D5
D4
D3
D2
D1
D0
POR Def.
02
R
Device Status
ffovfl
ffunfl
rxffem
headerr
freqerr
cps[1] cps[0]
The operational status of the chip can be read from "Register 02h. Device Status".
Tel: +86-755-82973805
Fax: +86-755-82973550
E-mail: sales@hoperf.com
18

Related parts for RFM22B-868-S1