5149031-1 TE Connectivity, 5149031-1 Datasheet - Page 6

• Manufacturer Part Number: 5149031-1
• Description: Conn Backplane F 160 POS 1.27mm Press Fit RA Thru-Hole
• Manufacturer: TE Connectivity
• Type: Backplaner

Specifications of 5149031-1

• Pitch: 1.27 mm
• Number Of Contacts: 160
• Termination Method: Press Fit
• Mounting: Through Hole
• Contact Plating: Gold
• Product Type: Connector
• Mount Angle: Right Angle
• Termination Method To Pc Board: Through Hole - Solder
• Pcb Mount Retention: Without
• Guides: With
• Flame Retardant: Yes
• Bus Bar Material: Phosphor Bronze
• Tail Length (mm [in]): 3.18 [0.125]
• Bus Bar Mating Area Plating: Gold (30)
• Bus Bar Termination Area Plating: Matte Tin with Nickel underplated
• Number Of Positions: 160
• Signal Contact Material: Phosphor Bronze
• Signal Contact Mating Area Plating: Gold (30)
• Signal Contact Termination Area Plating: Matte Tin with Nickel underplated
• Connector Style: Receptacle
• Housing Material: High Temperature Thermoplastic
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev A
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product m eets requirem ents of Figure 1. Failures attributed to
equipm ent, test setup or operator deficiencies shall not disqualify product. W hen product failure occurs,
corrective action shall be taken and sam ples resubm itted for qualification. Testing to confirm corrective
action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan will specify sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with applicable product drawing and
this specification.
Sam ple Selection
Connector housings and contacts shall be prepared in accordance with applicable Instruction
Sheets and shall be selected at random from current production. Test group 1 shall consist of 5
connectors each of the m inim um and m axim um sizes available. Test groups 2 and 3 shall consist
of 5 connectors each. All tests requiring individual contact m easurem ents shall be conducted on
30 contacts random ly selected over the 5 connectors. Test groups 1 and 2 shall be m ounted on
printed circuit boards designed to accom m odate vibration and physical shock fixturing providing a
series circuit for all contacts with access to m easure term ination resistance. Test group 3 shall not
be printed circuit board m ounted. Each sam ple shall consist of a plug and receptacle assem bly.
Test Sequence
Qualification inspection shall be verified by testing sam ples as specified in Figure 3.
108-1272
6 of 8