E53-COV04 Omron, E53-COV04 Datasheet - Page 22

• Manufacturer Part Number: E53-COV04
• Description: E5CJ TERMINAL COVER
• Manufacturer: Omron

Specifications of E53-COV04

• Accessory Type: Terminal Cover
• For Use With/related Products: E5CJ
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: E53COV04

Setting Flowchart
3-2
Display Level 0
Display level 1
Engineering Level
Each parameter is set with the Up Key or Down
Key. Each value set will be effective on pressing
the Display Key or Level Key or 2 s after it is se-
lected if Display Key or Level Key is not pressed.
No value can be, however, changed when the
key protection switch is ON.
The parameters in parentheses are changed if their initial
values are changed on the engineering level.
Set point setting
Alarm 2 setting
Display level 0
Alarm 1 setting
Setting Flowchart
Level Key
Press for 1 s min.
Level Key
Press for 1 s min.
Output display
Control period setting
Hysteresis setting
The Thermac E5jJ Temperature Controller starts control at the set point and
continues controlling even while set values are being input for each display level.
Therefore, when operating the E5jJ after inputting all the set values, turn the
power supply to the Temperature Controller off and then on again.
All parameters for the E5jJ Temperature Controller are divided into three levels
according to how frequently they are used.
Parameters that are changed frequently are ranked as display level 0 parame-
ters.
Parameters that are not changed frequently are ranked as display level 1 pa-
rameters.
Parameters that are changed with only a few applications are ranked as engi-
neering level parameters.
Set point 0 setting
Set point 1 setting
(Set point 2 setting)
(Input shift value setting)
Heater current value display
(Set point 3 setting)
Heater burnout alarm setting
Proportional band setting
Integral time setting
Display level 1
Derivative time setting
Manual reset value setting
OFF
Pin 4 of the func-
tion selector
Refer to Section 9 Engineering Level
Settings for details on each parameters
on the engineering level and how to
change them.
C/ F selection
Stable range
Alpha
Automatic return of display mode
Standby sequence reset method
ON
Input shift display selection
Alarm 1 hysteresis
Alarm 2 hysteresis
Set point lower limit
Engineering level
Set point upper limit
Event input 2 function selection
Section 3-2
19