K32-49HC Omron, K32-49HC Datasheet - Page 10

• Manufacturer Part Number: K32-49HC
• Description: COVER HARD FOR K3MA-F METER
• Manufacturer: Omron

Specifications of K32-49HC

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: K3249HC

Installation
1. Insert the K3MA-F into the panel cut-out hole.
2. For a waterproof installation, insert the rubber gasket onto the
3. Fit the adaptor into the grooves on the left and right sides of the
■ LCD Angle of View
The K3MA is designed to provide the best visibility at the angles
shown in the following diagram.
■ Rubber Packing
K32-P1
■ Wiring Precautions
• Use crimp terminals.
• Tighten the terminal screws to a torque of approximately 0.5 N m.
• To avoid the influence of noise, route signal lines and power lines
separately.
body of the K3MA-F.
rear case, then push it until it contacts the panel to secure the
K3MA-F.
(Sold Separately)
10°
30°
If the rubber packing is lost or damaged, it can
be ordered using the following model number:
K32-P1.
(Depending on the operating environment,
deterioration, contraction, or hardening of the
rubber packing may occur and so, in order to
ensure the level of waterproofing specified in
NEMA4, periodic replacement is
recommended.)
Note: Rubber packing is provided with the
Controller.
■ Wiring
• Use the following M3 crimp terminals.
■ Unit Labels (Provided)
• The unit labels are not attached to the K3MA-F. Select the desired
Note: For scales and gauges, use the unit labels that are specified by
labels from the provided sheet.
the relevant laws or regulations.
5.8 mm max.
5.8 mm max.
K3MA-F
10