H7EC-NV Omron, H7EC-NV Datasheet - Page 10

• Manufacturer Part Number: H7EC-NV
• Description: COUNT TOTALIZER DC IN 30HZ/1KHZ
• Manufacturer: Omron
• Series: H7ECr

Specifications of H7EC-NV

• Count Rate: 30Hz or 1kHz Selectable
• Number Of Digits/alpha: 8
• Input Type: Transistor
• Voltage - Supply: None Required (Battery Included)
• Display Type: LCD Non-Backlit
• No. Of Digits / Alpha: 8
• Digit Height: 8.6mm
• Power Consumption: 300mW
• Operating Temperature Range: -10°C To +55°C
• Svhc: No SVHC (15-Dec-2010)
• Count Speed Max: 1kHz
• External Depth: 48.5mm
• Display Scan Rate Max: 1kHz
• Display Scan Rate Min: 30Hz
• Equipment Type: Self-Powered Count Totalizer
• Dimensions: 48 mm L x 24 mm W x 48.5 mm H
• Mounting Style: Panel
• Primary Voltage Rating: 4.5 VDC to 30 VDC
• Termination Style: Screw
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: H7EC-NV; H7ECNV; Z3008

H7EC
J RESET INPUT AND COUNT INPUT
The H7EC operates using its built-in Battery. If the H7EC is
connected to a device that has +V and OUT terminals that are
connected with a diode as shown in the circuit diagram, the
circuit indicated by the arrow 1 or 2 will be formed when the
device is turned OFF. As a result, the H7EC may be reset or
count by one. It is recommended that such devices not be
connected to the H7EC.
If an excessive voltage is applied to the count or reset input
terminals, the internal elements may be damaged.
Ensure that the following voltages are not exceeded:
SPNP/NPN universal voltage input model: 30 VDC
SAC/DC voltage input model:
Do not remove the outer case when voltage is being applied to
the power supply terminals or to the input terminals.
The input for the H7Ej-NFV-j is a high-impedance circuit so
influence from an induced voltage may result in malfunction.
When the input signal wiring is longer than 10 m (stray
capacitance of 120 pF/m, at room temperature), a CR filter or a
bleeder resistor should be connected.
At count input:
At reset input:
No-voltage input model: 3 VDC
Count input
or reset input
240 VAC (peak voltage: 338V)
240 VDC
3 VDC (no-voltage input)
10
J COUNT INPUT OR RESET INPUT TO
PNP/NPN Universal DC Voltage Input
Note:
No-voltage Input
Note: 1. The leakage current of the transistor used for input
MORE THAN ONE H7E COUNTER AT
A TIME
2. The forward voltage of the diode must be as low as
H (Reset ON) level must be 4.5 V minimum.
H =
must be less than 1 µA.
possible (i.e., 0.1 V maximum with an I
the voltage between terminals 3 and 4 will be 0.5 V
when the reset input is ON.
4.7 (kΩ)/N + V
4.7 (kΩ)/N + R
or
or
F
of 20 µA) so
H7EC
or