CUB4TC00 Red Lion Controls, CUB4TC00 Datasheet - Page 7

• Manufacturer Part Number: CUB4TC00
• Description: METER PANEL LCD THERMOCOUPLE
• Manufacturer: Red Lion Controls
• Series: CUB4r
• Type: Thermocoupler

Specifications of CUB4TC00

• Display Type: LCD Non-Backlit
• Display Face Size: 2.95" L x 1.54" W (74.9 x 39.1mm)
• Display Digits: 5
• Display Digits - Height: 0.480" (12.19mm)
• Backlight: Without
• Mounting Type: Panel Mount
• Termination: Screw Terminals
• Voltage - Supply: 9 V ~ 26 V
• Applications: Thermocouple Input - Type T, E, J, K, R, S, B, N, or mV
• Number Of Digits/alpha: 5
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q1421239; Q763911

INSTALLATION
when properly installed. The units are intended to be mounted on an
enclosed panel. The viewing window and buttons are factory sealed
for a wash down environment. A sponge rubber gasket and
mounting clip are provided for sealing the unit in the panel cut-out.
Installation Environment
exceed the maximum operating temperature and
provides good air circulation. Placing the unit near
devices that generate excessive heat should be avoided.
neutral soap product. Do NOT use solvents.
the aging process of the bezel.
operate the buttons of this unit.
1. Cut the panel opening to the specified dimensions. Remove burrs and clean
2. Carefully slide the panel gasket over the rear of the unit to the back of the
3. Assemble the nut fastener and mounting screw onto both sides of the
4. Install the unit through the panel cut-out until the front bezel flange contacts
5. Slide the mounting clip over the rear of the unit until the mounting clip is
APPLICATION FOR CUB4RT
Relative Temperature Error Display
temperature of an oven and the desired temperature of 475.0°F. If the
temperature of the oven is 464.8°F, the display should read -10.2°F. A
Pt392 type RTD is used.
temperature indication.
the temperature relative to 475.0°F.
The meter meets NEMA 4X/IP65 requirements for indoor use,
The unit should be installed in a location that does not
The bezel should be cleaned only with a soft cloth and
Continuous exposure to direct sunlight may accelerate
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to
The following procedure assures proper installation:
around the panel opening.
bezel.
mounting clip. The tip of the screw should not project from the hole in the
mounting clip.
the panel.
against the back of the panel. The mounting clip has latching features which
engage into mating features on the housing.
A customer desires to display the difference between the actual
The user offset capability of the CUB4RT allows for this type of
Desired oven temp = 475.0°F, set offset for -475.0. Unit will display
Programming:
tYPE
dIsp
FLtEr
rANGE
OFSEt
=
=
=
=
= -
pt392
0. 0 °F
1
5 °F
475. 0 °F
7
6. Alternately tighten each screw to ensure uniform gasket pressure. Visually
7. If the gasket is not adequately compressed, and the mounting screws can no
inspect the front panel gasket. The gasket should be compressed to about 75
to 80% of its original thickness. (Recommended torque is 28 to 36 in-oz.) If
not, gradually turn the mounting screws to further compress the gasket.
longer be turned, loosen the mounting screws and check that the mounting
clip is latched as close as possible to the panel.
Repeat the procedure for tightening the mounting screws.