DS1089LU-866+ Maxim Integrated Products, DS1089LU-866+ Datasheet
![IC ECONOSCILLATOR SS 8-USOP](/photos/1/39/13936/406-8-msop_sml.jpg)
DS1089LU-866+
Specifications of DS1089LU-866+
Related parts for DS1089LU-866+
DS1089LU-866+ Summary of contents
Page 1
... PART FREQUENCY (MHz) DS1089LU-21G DS1089LU-4CL DS1089LU-22F DS1089LU-23C DS1089LU-450 DS1089LU-866 DS1089LU-yxx Fixed up to 66.6 Add “/T” for Tape and Reel. Custom frequencies available, contact factory. EconOscillator is a trademark of Dallas Semiconductor Corp. For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at 1-888-629-4642, or visit Maxim’ ...
Page 2
Center Spread-Spectrum EconOscillator™ ABSOLUTE MAXIMUM RATINGS Voltage on V Relative to Ground.......................-0.5V to +6.0V CC PDN, OE, SDA, Voltage on SPRD, SCL Relative to Ground* ........................-0. Operating Temperature Range ...........................-40°C to +85°C *This voltage must not exceed ...
Page 3
Center Spread-Spectrum EconOscillator™ MASTER OSCILLATOR CHARACTERISTICS (V = +2.7V to +3.6V -40°C to +85° PARAMETER SYMBOL Internal Master Oscillator Frequency ∆f Master Oscillator Frequency Tolerance Voltage Frequency Variation Temperature Frequency Variation (Note 4) Dither Frequency ...
Page 4
Center Spread-Spectrum EconOscillator™ AC ELECTRICAL CHARACTERISTICS— +2.7V to +3.6V -40°C to +85°C, unless otherwise noted. Timing referenced PARAMETER SYMBOL SCL Clock Frequency f Bus Free Time Between Stop and t Start ...
Page 5
Center Spread-Spectrum EconOscillator™ 3.3V +25°C, unless otherwise noted ACTIVE SUPPLY CURRENT vs. SUPPLY VOLTAGE +25°C, A 66MHz OUTPUT UNLOADED 50MHz 130kHz 33MHz 2 0 2.7 3.0 3.3 ...
Page 6
Center Spread-Spectrum EconOscillator™ 3.3V +25°C, unless otherwise noted DUTY CYCLE vs. SUPPLY VOLTAGE +25° 66MHz 50MHz 33MHz 130kHz 48 2.7 3.0 3.3 3.6 SUPPLY VOLTAGE ...
Page 7
Center Spread-Spectrum EconOscillator™ PDN OE SDA SERIAL ADDRESS INTERFACE BITS SCL ADDR J3 J2 WRITE EE COMMAND EEPROM WRITE CONTROL EEPROM GND PRESCALER SPRD Detailed Description Master ...
Page 8
Center Spread-Spectrum EconOscillator™ Two user control signals control the output. The output enable pin (OE) gates the output buffer and the power- down pin (PDN) disables the master oscillator and turns off the output for power-sensitive applications. (Note: the ...
Page 9
Center Spread-Spectrum EconOscillator™ When dither is enabled (by selecting a dither frequency setting greater than 0 with SPRD high), the master oscillator frequency is dithered around the center fre- quency by the selected percentage from the pro- grammed f ...
Page 10
Center Spread-Spectrum EconOscillator™ WRITE EE Command The WRITE EE command is useful in closed-loop appli- cations where the registers are frequently written. In applications where the register contents are frequently written, the WC bit should be set to 1 ...
Page 11
Center Spread-Spectrum EconOscillator™ SDA t BUF t LOW SCL t HD:STA STOP START 2 Figure Characteristics 2 TYPICAL I C WRITE TRANSACTION MSB START A2* A1* A0* DEVICE READ/ DEVICE IDENTIFIER ...
Page 12
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 12 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © 2004 Maxim Integrated Products is a registered trademark of Dallas Semiconductor Corporation. ...