MC88915TFN160 Freescale Semiconductor, MC88915TFN160 Datasheet - Page 19
![IC DRIVER CLK PLL 160MHZ 28-PLCC](/photos/6/56/65665/375-28-plcc_sml.jpg)
MC88915TFN160
Manufacturer Part Number
MC88915TFN160
Description
IC DRIVER CLK PLL 160MHZ 28-PLCC
Manufacturer
Freescale Semiconductor
Type
Clock Driver, Fanout Distribution, Multiplexerr
Datasheet
1.MC88915TFN70R2.pdf
(21 pages)
Specifications of MC88915TFN160
Pll
Yes
Input
TTL
Output
CMOS, TTL
Number Of Circuits
1
Ratio - Input:output
3:8
Differential - Input:output
No/No
Frequency - Max
160MHz
Divider/multiplier
Yes/Yes
Voltage - Supply
4.75 V ~ 5.25 V
Operating Temperature
0°C ~ 70°C
Mounting Type
Surface Mount
Package / Case
28-PLCC
Frequency-max
160MHz
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
MC88915TFN160
Manufacturer:
Freescale Semiconductor
Quantity:
10 000
MC88915T System Level Testing Functionality
OE/RST pin low will put all outputs (except for LOCK) into the high impedance state. As long as the PLL_EN pin is low, the
Q0–Q4, Q5, and the Q/2 outputs will remain reset in the low state after the OE/RST until a falling SYNC edge is seen. The 2X_Q
output will be the inverse of the SYNC signal in this mode. If the 3–state functionality will be used, a pull–up or pull–down resistor
must be tied to the FEEDBACK input pin to prevent it from floating when the fedback output goes into high impedance.
and disabling the VCO. In this mode the outputs are directly driven by the SYNC input (per the block diagram). This mode can
also be used for low frequency board testing.
Note: If the outputs are put into 3–state during normal PLL operation, the loop will be broken and phase–lock will be lost. It will
take a maximum of 10mS (tLOCK spec) to regain phase–lock after the OE/RST pin goes back high.
MOTOROLA
3–state functionality has been added to the 100MHz version of the MC88915T to ease system board testing. Bringing the
With the PLL_EN pin low the selected SYNC signal is gated directly into the internal clock distribution network, bypassing
Figure 7. Representation of a Potential Multi–Processing Application Utilizing the MC88915T
for Frequency Multiplication and Low Board–to–Board Skew
19