DS1075Z-800 Maxim Integrated Products, DS1075Z-800 Datasheet - Page 6

• Manufacturer Part Number: DS1075Z-800
• Description: ECONOSCILLATOR/DIV MHZ 8-SOIC
• Manufacturer: Maxim Integrated Products
• Series: EconOscillator™r
• Type: Oscillator, Fixed Frequency, Dualr

Specifications of DS1075Z-800

• Frequency: 800MHz
• Voltage - Supply: 4.75 V ~ 5.25 V
• Current - Supply: 35mA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Count: -

DS1075
OPERATION OF OUTPUT ENABLE
Since the output enable, internal master oscillator and/or external master oscillator are likely all
asynchronous there is the possibility of timing difficulties in the application.
To minimize these
difficulties the DS1075 features an “enabling sequencer” to produce predictable results when the device is
enabled and disabled. In particular the output gating is configured so that truncated output pulses can
never be produced.
ENABLE TIMING
The output enable function is produced by sampling the OE input with the output from the prescaler mux
(MCLK) and gating this with the output from the programmable divider. The exact behavior of the
device is therefore dependent on the setup time (t
) from a transition on the OE input to the rising edge
SU
of MCLK. If the actual setup time is less than t
then one more complete cycle of MCLK will be
SUEM
required to complete the enable or disable operation (see diagrams). This is unlikely to be of any
consequence in most applications, and then only if the value for N is small. In general, the output will
make its first positive transition between approximately one and two clock periods of MCLK after the
rising edge of OE.
FIGURE 4
DISABLE TIMING
If OE goes low while OUT is high, the output will be disabled on the completion of the output pulse. If
OUT is low, the disabling behavior will be dependent on the setup time between the falling edge of OE
and the rising edge of MCLK. If t
< t
the result will be one additional pulse appearing on the
SU
SUEM
output before disabling occurs. If the device is in divide-by-one mode, the disabling occurs slightly
differently. In this case if t
> t
one additional output pulse will appear, if t
< t
then two
SU
SUEM
SU
SUEM
additional output pulses will appear.
The following diagrams illustrate the timing in each of these cases.
6 of 18