DS1075Z-644 Maxim Integrated Products, DS1075Z-644 Datasheet - Page 4

• Manufacturer Part Number: DS1075Z-644
• Description: ECONOSCILLATOR/DIV 644MHZ 8-SOIC
• Manufacturer: Maxim Integrated Products
• Series: EconOscillator™r
• Type: Oscillator, Fixed Frequency, Dualr

Specifications of DS1075Z-644

• Frequency: 644MHz
• Voltage - Supply: 4.75 V ~ 5.25 V
• Current - Supply: 35mA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Count: -

the function of the registers are described. The register settings are nonvolatile, the values being stored
automatically in EEPROM when the registers are programmed.
Note: The register bits cannot be used to make mode or frequency changes on the fly. Changes can only
be made by powering the device up in “Programming” mode. For them to be become effective the device
must then be powered down and powered up again in “Operation” mode.
For programming purposes the register bits are divided into two 9-bit words, the “MUX” word
determines mode of operation and prescaler values. The “DIV” word sets the value of the programmable
divider.
MUX WORD Figure 2
E/ I
This bit selects either the internal oscillator or the external/ crystal reference.
Table 1
DIV1
This bit allows the master clock to be routed directly to the output (DIV1=1). The N programmable
divider is bypassed so the programmed value of N is ignored. The frequency of the output (f
INTCLK or EXTCLK depending on which reference has been selected. If the Internal clock is selected
the M prescaler is also bypassed (the bit values of MSEL and M are ignored) so in this case f
=INTOSC (which also equals MCLK and INTCLK). If DIV1=0 the prescaler and programmable divider
function normally.
MSEL
This bit determines whether or not the M prescaler is bypassed.
determined by the M bit.
M
This bit sets the divide-by number for the prescaler. M=0 results in divide-by-4, M=1 results in divide-
by-2. The setting of this bit is irrelevant if either DIV1=1 or
MSEL
(MSB)
PDN
BIT
0*
0
0
1
1
1
=0 will switch in the prescaler (unless overridden by DIV1=1), with a divide-by number
1=External/Crystal
0=Internal Oscillator
however, if the PDN bit is set to zero the E/I bit will be overridden by the logic level on the
PDN
/
SELX
0*
E/ I
X
X
X
0
1
pin.
PDN
0*
PIN
/
0
1
0
1
1
SELX
EN0
EXTERNAL/CRYSTAL
INTERNAL
POWER-DOWN
INTERNAL
EXTERNAL/CRYSTAL
4 of 18
PDN
* These bits must be set to zero
OSCILLATOR
MSEL
MODE
M
=1.
MSEL
MSEL
=1 will bypass the prescaler.
DIV1
OUT
(LSB)
) will be
E/
I
OUT