DS1075Z-802 Maxim Integrated Products, DS1075Z-802 Datasheet - Page 7

• Manufacturer Part Number: DS1075Z-802
• Description: ECONOSCILL CUSTOM 40KHZ 8-SOIC
• Manufacturer: Maxim Integrated Products
• Series: EconOscillator™r
• Type: Oscillator, Fixed Frequency, Dualr

Specifications of DS1075Z-802

• Frequency: 802MHz
• Voltage - Supply: 4.75 V ~ 5.25 V
• Current - Supply: 35mA
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Count: -

DS1075
Figure 5
Figure 6
SELECT TIMING
If the PDN bit is set to “0”, the
/
pin can be used to switch between the internal oscillator and
PDN
SELX
an externalor crystal reference. The “Enabling Sequencer” is again employed to ensure this transition
occurs in a glitch-free fashion. Two asynchronous clock signals are involved, INTCLK is the internal
reference oscillator divided by one or whatever value of M is selected. EXTCLK is the clock signal fed
into the OSCIN pin, or the clock resulting from a crystal connected between OSCIN and XTAL. The
behavior of OUT0 is described in the following paragraphs, the OUT pin will behavior similarly but will
be divided by N.
FROM INTERNAL TO EXTERNAL CLOCK
This is accomplished by a high to low transition on the
pin. This transaction is detected on the
SELX
falling edge of INTCLK. The output OUT0 will be held low for a minimum of half the period of
INTCLK (t
/2), then if EXTCLK is low it will be routed through to OUT0. If EXTCLK is high the
I
switching will not occur until EXTCLK returns to a low level.
7 of 18