LTC2428CG#PBF Linear Technology, LTC2428CG#PBF Datasheet - Page 34
![IC ADC 20BIT 8CH MICROPWR 28SSOP](/photos/6/59/65971/161-28-ssop_sml.jpg)
LTC2428CG#PBF
Manufacturer Part Number
LTC2428CG#PBF
Description
IC ADC 20BIT 8CH MICROPWR 28SSOP
Manufacturer
Linear Technology
Datasheet
1.LTC2424CGPBF.pdf
(36 pages)
Specifications of LTC2428CG#PBF
Number Of Bits
20
Sampling Rate (per Second)
7.5
Data Interface
MICROWIRE™, Serial, SPI™
Number Of Converters
1
Power Dissipation (max)
1mW
Voltage Supply Source
Single Supply
Operating Temperature
0°C ~ 70°C
Mounting Type
Surface Mount
Package / Case
28-SSOP (0.200", 5.30mm Width)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
APPLICATIONS
LTC2424/LTC2428
could be used to measure the case temperature of the
RTD-based thermal power measurement scheme described
previously. In general, thermistors yield very good resolu-
tion over a limited temperature range. For the half-bridge
arrangement shown, the LTC2428 can measure tempera-
ture changes over nearly 5 orders of magnitude.
Connected to the LTC2428’s CH6 input, an infrared ther-
mocouple (Omega Engineering OS36-1) can be used in
limited range, noncontact temperature measurement ap-
plications or applications where high levels of infrared
light must be measured. Given the LTC2428’s 1.2ppm
noise performance, measurement resolution using infra-
red thermocouples is approximately 0.25 C—equivalent
to the resolution of a conventional Type J thermocouple.
These infrared thermocouples are self-contained: 1) they
do not require external cold junction compensation; 2)
they cannot use conventional open thermocouple detec-
tion schemes; and 3) their output impedances are high,
approximately 3k . Alternatively, conventional thermo-
couples can be connected directly to the LTC2428 (not
shown) and cold junction compensation can be provided
by an external temperature sensor connected to a different
34
U
INFORMATION
U
W
U
RMS
channel (see the thermistor circuit on CH5) or by using the
LT1025, a monolithic cold-junction compensator IC.
The components connected to CH7 are used to sense
daylight or photodiode current with a resolution of 300pA.
In the figure, the photodiode is biased in photoconduc-
tive mode; however, the LTC2428 can accommodate
either photovoltaic or photoconductive configurations.
The photodiode chosen (Hammatsu S1336-5BK) pro-
duces an output of 500mA per watt of optical illumination.
The output of the photodiode is dependent on two factors:
active detector area (2.4mm • 2.4mm) and illumination
intensity. With the 5k resistor, optical intensities up to
368W/m
1000W/m
resolution of 1nA, the optical dynamic range covers 5
orders of magnitude.
The application circuits shown connected to the LTC2428
demonstrate the mix-and-match capabilities of this multi-
plexed-input, high resolution
signals and high level signals can be accommodated with
a minimum of additional circuitry.
2
2
at 960nM (direct sunlight is approximately
) can be measured by the LTC2428. With a
ADC. Very low level