AS1528-BTDR austriamicrosystems, AS1528-BTDR Datasheet - Page 18

• Manufacturer Part Number: AS1528-BTDR
• Description: IC A/D 10-BIT 1-CH 150K 8-TDFN
• Manufacturer: austriamicrosystems

Specifications of AS1528-BTDR

• Number Of Bits: 10
• Sampling Rate (per Second): 150k
• Data Interface: MICROWIRE™, QSPI™, Serial, SPI™
• Number Of Converters: 1
• Voltage Supply Source: Single Supply
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 8-WDFN Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AS1528/AS1529
Datasheet - A p p l i c a t i o n I n f o r m a t i o n
Layout and Grounding Considerations
The AS1528/AS1529 require proper layout and design procedures for optimum performance.
Figure 29. Recommended Ground Design
www.austriamicrosystems.com
!
!
!
!
!
!
!
!
Use printed circuit boards; wirewrap boards should not be used.
Separate analog and digital traces from each other. Analog and digital traces should not run parallel to each other
(especially clock traces).
Digital traces should not run beneath the AS1528/AS1529.
Use a single-point analog ground at GND, separate from the digital ground
log grounds and DGND to this star ground point for further noise reduction. No other digital system ground should
be connected to this single-point analog ground. The ground return to the power supply for this ground should be
low impedance and as short as possible for noise-free operation.
High-frequency noise in the V
this supply to the single-point analog ground with 0.1µF and 4.7µF bypass capacitors
capacitors should be placed as close to the device as possible for optimum power supply noise-rejection. If the
power supply is very noisy, a 10Ω resistor can be connected as a low-pass filter to attenuate supply noise
Power components such as the inductor, converter IC, filter capacitors, and output diode should be placed as close
together as possible, and their traces should be kept short, direct, and wide.
Keep the voltage feedback network very close to the device, within 5mm (0.2”) of the pin.
Keep noisy traces, such as those from the pin LX, away from the voltage feedback network and guarded from
them using grounded copper traces.
Supplies
Power
DD
power supply may affect the AS1528/AS1529 high-speed comparator. Bypass
+5 or +3V
GND
GND
+5 or +3V
(Optional)
5Ω
Revision 1.02
0.1µF
+5 or +3V
DGND
GND
V
DD
4
1
(see Figure
AS1528/
Circuitry
AS1529
Digital
(see Figure
29). Connect all other ana-
29). The bypass
18 - 21