487940-3 TE Connectivity, 487940-3 Datasheet - Page 5

• Manufacturer Part Number: 487940-3
• Description: FFC SDR TAB 100 FULL SN-PB
• Manufacturer: TE Connectivity

Specifications of 487940-3

• Rohs Compliant: NO
• Product Type: Contact
• Termination Method To Wire/cable: Solder Tab
• Wire/cable Type: FFC
• Solder Tail Contact Plating: Matte Tin
• Centerline (mm [in]): 1.27 [0.050]
• Contact Type: Pin
• Contact Plating, Mating Area, Material: Matte Tin
• Rohs/elv Compliance: Not ELV/RoHS compliant
• Lead Free Solder Processes: Reflow solder capable to 245°C, Reflow solder capable to 260°C
• Packaging Method: Strip
• Lead Free Status / Rohs Status: No

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and
this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. Test groups 1, 2, 3, 4 and 5 shall each consist of a minimum of
3 cable assemblies with a minimum of 10 contacts of each plating type per cable assembly. Mating
contact circuits in each cable assembly shall be randomly selected and identified. Unless otherwise
specified, these contacts shall be used for all measurements required in these test groups. Test
group 6 shall consist of 6 unterminated solder tabs.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-16022
5 of 6