5-1479184-2 TE Connectivity, 5-1479184-2 Datasheet - Page 6

• Manufacturer Part Number: 5-1479184-2
• Description: KIT,8P,MOD PLUG,STRANDED,CAT6
• Manufacturer: TE Connectivity

Specifications of 5-1479184-2

• Product Type: Connector
• Number Of Contacts Loaded: 8
• Cable Style: Round Stranded
• Performance Category: Cat 6
• Latch Style: Standard
• Keyed: No
• Small Conductor: No
• Qty./box: 500
• Shield Material: Brass
• Shielded: Yes
• Solder Tail Contact Plating: Gold Flash over Nickel
• Number Of Positions: 8
• Conductor O.d. (mm [in]): 0.89 – 1.00 [0.035 – 0.040]
• Cable Jacket Outer Diameter Range (mm [in]): 6.00 – 7.00 [0.236 – 0.280]
• Shield Plating: Nickel
• Preloaded: Yes
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (50)
• Connector Style: Plug - Modular
• Housing Material: Polycarbonate GF
• Ul Flammability Rating: UL 94V-2
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Box

4.
4.1.
4.2.
4.3.
4.4.
Rev K
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process
or controlling industry specification, product assurance shall coordinate requalification testing, consisting
of all or part of the original testing sequence as determ ined by developm ent/product, quality and
reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and sam ples resubm itted for qualification. Testing to
confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan shall specify the sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Specim en Selection
Plugs and jacks shall be prepared in accordance with applicable Instruction Sheet and shall be
selected at random from current production. Test groups 1, 2, 3, 4 and 5 shall each consist of 5
specim ens (plug and jack). If not specified, Category 6 plugs shall be used. Test groups 6, 7, 8, 9
and 10 shall each consist of 5 specim ens of each of the following subgroups: 1) SL Category 5e or
Category 6 jack and Category 6 plug; 2) SL Category 5e or Category 6 jack and high perform ance
plug; 3) SL Category 3 jack and 6 position plug. Test group 8, 6 position plug shall have no coring
where pins 1 and 8 are located in receiving jack, as shown in TIA-968-A Figure 6.3. Test group 11
shall consist of 5 specim ens of shielded jacks and plugs.
Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
108-1990
6 of 8