748610-8 TE Connectivity, 748610-8 Datasheet - Page 3

• Manufacturer Part Number: 748610-8
• Description: CONT,HD22 CS SCKT
• Manufacturer: TE Connectivity

Specifications of 748610-8

• Rohs Compliant: YES
• Product Type: Contact
• Product Series: HDP-22 (Crimp Snap)
• Termination Method To Wire/cable: Crimp
• Wire Insulation Diameter (mm [in]): 0.76 – 1.02 [0.030 – 0.040]
• Insulation Support: Yes
• Grade: Standard
• Contact Retention In Housing: Crimp Snap-In
• Solder Tail Contact Plating: Gold (50)
• Wire Range (mm² [awg]): 0.08 - 0.40 [28-22]
• Contact Type: Socket
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold (50)
• Contact Size: 22
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Strip
• Packaging Quantity: 20,000/Reel

Physical shock.
Mating force.
Unmating force.
Contact insertion force.
Contact retention force.
Contact engaging force.
Contact separating force.
Crimp tensile.
Rev B
Test Description
No discontinuities of 1 microsecond
or longer duration.
See Note.
Note: Ground indents are on the
plug.
Note: Ground indents are on the
plug.
Three pounds maximum per
contact.
Contacts shall not dislodge from the
connector housing.
Eight ounces maximum per contact. TE Spec 109-35.
.75 ounce minimum per contact.
Size Positions
Size Positions
1
2
3
4
5
1
2
3
4
5
Wire Size
(AWG)
22
24
26
28
Figure 1 (continued)
15
26
44
62
78
15
26
44
62
78
Requirement
(lbs minimum)
Crimp Tensile
Ground Indents
Ground Indents
(lbs maximum)
(lbs maximum)
With Without
16.5
23.3
29.3
With Without
16.5
23.3
29.3
5.6
9.8
5.6
9.8
12
4.5
2.7
8
33
38
46
52
58
33
38
46
52
58
TE Spec 109-26-1.
Subject mated specimens to 50 G's
half-sine shock pulses of 11
milliseconds duration. Three shocks
in each direction applied along 3
mutually perpendicular planes, 18
total shocks.
See Figure 4.
TE Spec 109-42, Condition A.
Measure force necessary to mate
specimens at a maximum rate of 1
inch per minute using a free-floating
fixture.
TE Spec 109-42, Condition A.
Measure force necessary to unmate
specimens at a maximum rate of 1
inch per minute.
TE Spec 109-41.
Measure force necessary to insert
contact into housing.
TE Spec 109-30.
Apply axial load of 5 pounds to
contacts and hold for 60 seconds.
Measure force necessary to insert
gage A to a depth of .200.
See Figure 5.
TE Spec 109-35.
Size 2 times using gage A, then
measure force necessary to insert
gage B to a depth of .200. Measure
force to separate.
See Figure 5.
TE Spec 109-16.
Determine crimp tensile at a
maximum rate of 1 inch per minute.
Procedure
108-1268
3 of 8