MX7705EWE+T Maxim Integrated Products, MX7705EWE+T Datasheet - Page 16
![IC ADC 16BIT 2CH 16-SOIC](/photos/5/17/51709/175-16-soic_w__sml.jpg)
MX7705EWE+T
Manufacturer Part Number
MX7705EWE+T
Description
IC ADC 16BIT 2CH 16-SOIC
Manufacturer
Maxim Integrated Products
Datasheet
1.MX7705EPE.pdf
(33 pages)
Specifications of MX7705EWE+T
Number Of Bits
16
Sampling Rate (per Second)
500
Data Interface
MICROWIRE™, QSPI™, Serial, SPI™
Number Of Converters
1
Voltage Supply Source
Single Supply
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
16-SOIC (0.300", 7.50mm Width)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
16-Bit, Low-Power, 2-Channel,
Sigma-Delta ADC
16
______________________________________________________________________________________
PIN
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
CLKOUT
RESET
NAME
CLKIN
AIN2+
AIN1+
DRDY
DOUT
SCLK
AIN1-
REF+
AIN2-
GND
REF-
V
DIN
CS
DD
Serial Clock Input. Apply an external serial clock to transfer data to and from the device at data rates
of up to 5MHz.
Clock Input. Connect a crystal/resonator between CLKIN and CLKOUT, or drive CLKIN externally with
a CMOS-compatible clock source with CLKOUT left unconnected.
Clock Output. Connect a crystal/resonator between CLKIN and CLKOUT. When enabled, CLKOUT
provides a CMOS-compatible, inverted clock output. Set CLKDIS = 0 in the clock register to enable
CLKOUT. Set CLKDIS = 1 in the clock register to disable CLKOUT to conserve power.
Active-Low Chip-Select Input. CS selects the active device in systems with more than one device on
the serial bus. Drive CS low to clock data in on DIN and to clock data out on DOUT. When CS is high,
DOUT is high impedance. Connect CS to GND for 3-wire operation.
Active-Low Reset Input. Drive RESET low to reset the MX7705 to power-on reset status.
Channel 2 Positive Differential Analog Input
Channel 1 Positive Differential Analog Input
Channel 1 Negative Differential Analog Input
Positive Differential Reference Input
Negative Differential Reference Input
Channel 2 Negative Differential Analog Input
Active-Low Data-Ready Output. DRDY goes low when a new conversion result is available in the data
register. When a read-operation of a full output word completes, DRDY returns high.
Serial Data Output. DOUT outputs serial data from the data register. DOUT changes on the falling
edge of SCLK and is valid on the rising edge of SCLK. When CS is high, DOUT is high impedance.
Serial Data Input. Data on DIN is clocked in on the rising edge of SCLK when CS is low.
Power Input
Ground
FUNCTION
Pin Description