787614-1 TE Connectivity, 787614-1 Datasheet - Page 5

• Manufacturer Part Number: 787614-1
• Description: BAT INT,INS ASY W/TAB,5P,10.8V
• Manufacturer: TE Connectivity

Specifications of 787614-1

• Rohs Compliant: YES
• Product Type: Connector
• Connector Type: Housing
• Type Of Connector: Battery Interconnect
• Mount Angle: Vertical
• Pcb Mount Retention: Without
• Mounting Holes: Without
• Voltage (vac): 10.8
• Number Of Positions: 5
• Centerline (mm [in]): 5.00 [0.197]
• Weld Tab: With
• Contact Type: Socket
• Contact Base Material: Copper Alloy
• Contact Plating, Mating Area, Material: Nickel
• Connector Style: Receptacle
• Housing Material: Polycarbonate GF
• Ul Flammability Rating: UL 94V-0
• Housing Color: Black
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant

4.
4.1.
4.2.
4.3.
4.4.
Rev B
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that product meets requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective
action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with applicable product drawing and
this specification.
Sample Selection
Samples shall be prepared in accordance with applicable Instruction Sheets and shall be selected
at random from current production. Test group 1 shall consist of a minimum of 12 header
assemblies and 60 battery housing assemblies where a minimum of 6 header assemblies and 6
battery housing assemblies are used with each mating configuration per Figure 6. Test group 2
shall consist of minimum of 6 header assemblies and 30 battery housing assemblies and shall be
used in mating orientation 1 per Figure 6. Test group 3 shall consist of minimum of 6 header
assemblies and 6 battery housing assemblies and shall be used with mating orientation 1 per
Figure 6. Test groups 4 and 5 shall consist of minimum of 6 header assemblies and 6 battery
housing assemblies and shall be used with mating orientation 1 per Figure 6.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 2.
108-1501
5 of 8