MCP4011-103E/MS Microchip Technology, MCP4011-103E/MS Datasheet - Page 47

• Manufacturer Part Number: MCP4011-103E/MS
• Description: IC DGTL POT 10K 1CH 8MSOP
• Manufacturer: Microchip Technology

Specifications of MCP4011-103E/MS

• Taps: 64
• Resistance (ohms): 10K
• Number Of Circuits: 1
• Temperature Coefficient: 150 ppm/°C Typical
• Memory Type: Volatile
• Interface: Up/Down
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-MSOP, Micro8™, 8-uMAX, 8-uSOP,
• Resistance In Ohms: 10K
• End To End Resistance: 10kohm
• Track Taper: Linear
• No. Of Steps: 64
• Resistance Tolerance: ± 20%
• Supply Voltage Range: 1.8V To 5.5V
• Control Interface: Increment Decrement
• No. Of Pots: Single
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9.0
9.1
Currently there are three boards that are available that
can be used to evaluate the MCP401X family of
devices.
1.
2.
3.
4.
These boards may be purchased directly from the
Microchip web site at www.microchip.com.
© 2006 Microchip Technology Inc.
The MCP402X Digital Potentiometer Evaluation
Board kit (MCP402XEV) contains a simple dem-
onstration board utilizing a PIC10F206, the
MCP401X and a blank PCB, which can be pop-
ulated with any desired MCP4011/2/3/4 device
in a SOT-23-5, SOT-23-6 or 150 mil SOIC 8-pin
package.
This board has two push buttons to control when
the PIC
serial commands. The example firmware
demonstrates the following commands:
• Increment
• Decrement
• High-Voltage Increment and Enable
• High-Voltage Decrement and Enable
• High-Voltage Increment and Disable
• High-Voltage Decrement and Disable
The populated board (with the MCP4011) can
be used to evaluate the other MCP401X devices
by appropriately jumpering the PCB pads.
The SOT-23-5/6 Evaluation Board (VSUPEV2)
can be used to evaluate the characteristics of
the
devices.
The 8-pin SOIC/MSOP/TSSOP/DIP Evaluation
Board (SOIC8EV) can be used to evaluate the
characteristics of the MCP4011 device in either
the SOIC or MSOP package.
The MCP4XXX Digital Potentiometer Daughter
Board allows the system designer to quickly
evaluate the operation of Microchip Technol-
ogy's MCP42XXX and MCP402X Digital Poten-
tiometers. The board supports two MCP42XXX
devices and an MCP402X device, which can be
replaced with an MCP401X device.
The board also has a voltage doubler device
(TC1240A), which can be used to show the
WiperLock™
MCP4021.
WiperLock Technology
WiperLock Technology
WiperLock Technology
WiperLock Technology
DEVELOPMENT SUPPORT
Evaluation/Demonstration Boards
MCP4012,
®
microcontroller generates MCP402X
Technology
MCP4013
feature
and
MCP4014
of
the
MCP4011/2/3/4
DS21978C-page 47