DS1844S-050+ Maxim Integrated Products, DS1844S-050+ Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/4/417/maxim_integrated_products_sml.jpg)
DS1844S-050+
Manufacturer Part Number
DS1844S-050+
Description
IC POT DIG QUAD 50K 20-SOIC
Manufacturer
Maxim Integrated Products
Datasheet
1.DS1844E-050.pdf
(14 pages)
Specifications of DS1844S-050+
Taps
64
Resistance (ohms)
50K
Number Of Circuits
4
Temperature Coefficient
750 ppm/°C Typical
Memory Type
Volatile
Interface
2-Wire or 5-Wire Serial
Voltage - Supply
2.7 V ~ 5.5 V
Operating Temperature
-40°C ~ 85°C
Mounting Type
Surface Mount
Package / Case
20-SOIC (7.5mm Width)
Resistance In Ohms
50K
Number Of Pots
Quad
Taps Per Pot
64
Resistance
50 KOhms
Wiper Memory
Volatile
Digital Interface
Serial (2-Wire, 5-Wire)
Operating Supply Voltage
3.3 V or 5 V
Supply Current
2.5 mA
Maximum Operating Temperature
+ 85 C
Minimum Operating Temperature
- 40 C
Mounting Style
SMD/SMT
Supply Voltage (max)
5.5 V
Supply Voltage (min)
2.7 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.
Address Inputs, A0, A1, and A2, should be tied to either V
address selections.
Resistor inputs cannot go below GND by more than 0.5 volts or above V
volts.
-3dB cutoff frequency characteristics for the DS1844 depend on potentiometer total resistance:
DS1844-010; 1 MHz; DS1844-050; 200 kHz; DS1844-100; 100 kHz.
See Figure 3, 5-wire timing diagram.
For 5-wire control logic and V
= +0.6V.
Absolute linearity is used to measure expected wiper voltage versus measured wiper voltage as
determined by wiper position. The DS1844 is specified to provide an absolute linearity of ± 0.5
LSB.
Relative linearity is used to determine the change in wiper voltage between two adjacent wiper
positions. The DS1844 is specified to provide a relative linearity of ± 0.25 dB.
When used as a rheostat or variable resistor the temperature coefficient applies: 650 ppm/°C.
When used as a voltage divider or potentiometer, the effective temperature coefficient approaches
30 ppm/°C.
Maximum ICC active current is dependent on clock rates during serial port activity. Maximum
ICC active current is specified for 5 MHz clock rates, and worse case input logic levels.
t
on SDA or SCL terminals.
t
stable before
See Figure 8, 5-wire timing diagram.
Measured with load as shown in Figure 9.
Valid for V
Valid at 25°C only.
SETUP
SETUP
is the minimum time required for the port select input, PS, to be stable before any activity
is the minimum time required for the port select input, PS, and/or the R/
CC
RST
= 5V only.
becomes active (or goes to a high state).
CC
= 5V ±10%, maximum V
10 of 14
IL
CC
= +0.8V. For V
or GND depending on the desired
CC
CC
by more than 0.5
= 3.0V ±10%,V
W
input to be
IL