CS4385-CQZ Cirrus Logic Inc, CS4385-CQZ Datasheet - Page 40

• Manufacturer Part Number: CS4385-CQZ
• Description: IC DAC 8CH 114DB 192KHZ 48LQFP
• Manufacturer: Cirrus Logic Inc

Specifications of CS4385-CQZ

• Package / Case: 48-LQFP
• Number Of Bits: 24
• Data Interface: Serial
• Number Of Converters: 8
• Voltage Supply Source: Analog and Digital
• Power Dissipation (max): 520mW
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Conversion Rate: 216 KSPS
• Resolution: 24 bit
• Interface Type: Serial
• Operating Supply Voltage: 5 V
• Operating Temperature Range: + 85 C
• Maximum Power Dissipation: 390 mW
• Mounting Style: SMD/SMT
• Number Of Dac Outputs: 8
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: 598-1154 - BOARD EVAL FOR CS4385 DAC
• Settling Time: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 598-1063

40
6.4.2 Direct DSD Conversion (DIR_DSD)
6.4.3 Static DSD Detect (STATIC_DSD)
6.4.4 Invalid DSD Detect (INVALID_DSD)
6.4.5 DSD Phase Modulation Mode Select (DSD_PM_MODE)
6.4.6 DSD Phase Modulation Mode Enable (DSD_PM_EN)
Function:
When set to 0 (default), DSD input data is sent to the DSD processor for filtering and volume control func-
tions.
When set to 1, DSD input data is sent directly to the switched capacitor DACs for a pure DSD conversion.
In this mode, the full-scale DSD and PCM levels will not be matched (see
performance may be reduced, the volume control is inactive, and the 50 kHz low pass filter is not available
(see
Function:
When set to 1 (default), the DSD processor checks for 28 consecutive zeroes or ones and, if detected,
sends a mute signal to the DACs. The MUTEC pins will eventually go active according to the DAMUTE
register.
When set to 0, this function is disabled.
Function:
When set to 1, the DSD processor checks for greater than 24 out of 28 bits of the same value and, if de-
tected, will attenuate the data sent to the DACs. The MUTEC pins go active according to the DAMUTE
register.
When set to 0 (default), this function is disabled.
Function:
When set to 0 (default), the 128Fs (BCKA) clock should be input to DSD_SCLK for Phase Modulation
Mode. (See
When set to 1, the 64Fs (BCKD) clock should be input to DSD_SCLK for Phase Modulation Mode.
Function:
When set to 1, DSD phase modulation input mode is enabled, and the DSD_PM_MODE bit should be set
accordingly.
When set to 0 (default), this function is disabled (DSD normal mode).
Section 1
Figure 22 on page
for filter specifications).
28)
Section
1), the dynamic range
CS4385
DS671F2