641644-2 TE Connectivity, 641644-2 Datasheet - Page 3

• Manufacturer Part Number: 641644-2
• Description: CONTACT, SOCKET, 24AWG, IDC / IDT
• Manufacturer: TE Connectivity
• Series: MTA-100r

Specifications of 641644-2

• Connector Type: Wire To Board Contact
• Contact Plating: Tin
• Contact Material: Phosphor Bronze
• Contact Termination: IDC / IDT
• Wire Size (awg): 24
• Rohs Compliant: Yes
• Contact Gender: Socket
• Termination Method To Wire/cable: IDC LED
• Wire Size (mm² [awg]): 0.2² [24]
• Used For: MTA-100 Connectors
• Contact Configuration: Replacement Contacts
• Contact Plating, Mating Area, Material: Tin
• Contact Base Material: Phosphor Bronze
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Packaging Method: Loose Piece
• For Use With: MTA-100 Connectors

Vibration, sinusoidal.
Physical shock.
Durability.
Mating force.
Unmating force.
Thermal shock.
Humidity-temperature cycling.
Temperature life.
Mixed flowing gas.
Rev H
NOTE
Test Description
Shall meet visual requirements, show no physical damage and shall meet requirements of
additional tests as specified in Test Sequence in Figure 2.
No discontinuities of 1 microsecond
or longer duration.
See Note.
No discontinuities of 1 microsecond
or longer duration.
See Note.
See Note.
2 pounds maximum average per
contact.
0.8 pound minimum average per
contact.
See Note.
See Note.
See Note.
See Note.
ENVIRONMENTAL
Figure 1 (end)
Requirement
TE Spec 109-21-1.
Subject mated samples to 10-55-10
Hz traversed in 1 minute at .06 inch
total excursion. 2 hours in each of 3
mutually perpendicular planes.
TE Spec 109-26-1.
Subject mated samples to 50 G's
half-sine shock pulses of 11
milliseconds duration. 3 shocks in
each direction applied along 3
mutually perpendicular planes, 18
total shocks.
TE Spec 109-27.
Manually mate and unmate
samples with friction lock header for
25 cycles.
TE Spec 109-42, Condition A.
Measure force necessary to mate
samples with friction lock header
from point of initial contact to depth
of .200 inch at maximum rate of .5
inch per minute.
TE Spec 109-42, Condition A.
Measure force necessary to unmate
samples from friction lock header at
maximum rate of .5 inch per minute.
TE Spec 109-22.
Subject mated samples to 25 cycles
between -55 and 105° C.
AMP Spec 109-23-3, Condition B.
Subject mated samples to 10 cycles
between 25 and 65° C at 95% RH.
AMP Spec 109-43.
Subject mated samples to
temperature life at 85° C for 1000
hours.
AMP Spec 109-85-3.
Subject mated samples to
environmental class III for 20 days.
Procedure
108-1050
3 of 9