536510-3 TE Connectivity, 536510-3 Datasheet - Page 6
![HARD METRIC CONNECTOR, RECEPTACLE, 96POS](/photos/24/84/248471/4427837_sml.jpg)
536510-3
Manufacturer Part Number
536510-3
Description
HARD METRIC CONNECTOR, RECEPTACLE, 96POS
Manufacturer
TE Connectivity
Series
Z-PACKr
Specifications of 536510-3
Connector Type
Backplane
Row Pitch
2mm
Pitch Spacing
2mm
No. Of Contacts
96
Gender
Receptacle
Contact Termination
Right Angle Through Hole
No. Of Rows
4
Rohs Compliant
No
Number Of Rows
4
Number Of Positions / Contacts
96
Pitch
2 mm
Mounting Style
Press Fit
Housing Material
Liquid Crystal Polymer
Contact Material
Phosphor Bronze
Contact Plating
Gold
Product Type
Connector
Pcb Mounting Orientation
Right Angle
Post Type
Solder Post
Module Type
Signal
Voltage Rating (vac)
30
Termination Post Length (mm [in])
3.53 [0.139]
Number Of Signal Positions
96
Sequencing
No
Post Plating
Tin Lead over Nickel
Centerline, Matrix (mm [in])
2.00 x 2.00 [.079 x .079]
Contact Type
Socket
Contact Base Material
Phosphor Bronze
Contact Plating, Mating Area, Material
Gold (30)
Connector Style
Receptacle
Rohs/elv Compliance
ELV compliant, 5 of 6 Compliant
Lead Free Solder Processes
Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C, Reflow solder capable to 245°C, Reflow solder capable to 260°C, Pin-in-Paste capable to 245°C, Pin-in-Paste capable to 260°C
Applies To
Printed Circuit Board
Application
Free-Board
Lead Free Status / Rohs Status
Details
4.2.
4.3.
4.4.
Rev C
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets requirements of Figure 1. Failures attributed
to equipment, test setup or operator deficiencies shall not disqualify the product. When product failure
occurs, corrective action shall be taken and samples resubmitted for qualification. Testing to confirm
corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
2.
Test Sequence
Qualification inspection shall be verified by testing samples as specified in Figure 3.
Power connectors.
Power connector housings and contacts shall be prepared in accordance with applicable
Instruction Sheets and shall be selected at random from current production. All test groups
shall consist of 5 connectors each of the largest available size. All tests requiring individual
contact measurements shall be conducted on 30 contacts randomly selected over the 5
connectors. Test groups 1 and 2 shall be mounted on printed circuit boards designed to
accommodate vibration and physical shock fixturing providing a series circuit for all contacts
with access to measure termination resistance.
Contact Resistance Measurement Points
Figure 4
108-1441
6 of 8