794000-2 TE Connectivity, 794000-2 Datasheet - Page 5

• Manufacturer Part Number: 794000-2
• Description: CONTACT, SOCKET, 26-24AWG, SOLDER
• Manufacturer: TE Connectivity
• Series: MRr

Specifications of 794000-2

• Contact Material: Phosphor Bronze
• Contact Plating: Gold
• Contact Termination: Solder
• Wire Size (awg): 26-24
• Cable Diameter Min: 0.025"
• Rohs Compliant: Yes
• Contact Gender: Socket
• Product Type: Contact
• Strain Relief: With
• Wire/cable Type: Discrete Wire
• Termination Method To Wire/cable: Crimp
• Pcb Mount Retention: Without
• Contact - Rated Current (a): 9
• Hot Pluggable: No
• Operating Voltage Reference: AC
• Operating Voltage (vac): 250
• Wire/cable Size (awg): 24 – 26
• Wire/cable Size (mm²): 0.12 – 0.2
• Wire/cable Size (cma): 236.823 – 394.705
• Profile Height (y-axis) (mm [in]): 1.94 [0.076]
• Length (x-axis) (mm [in]): 16.76 [0.6598]
• Width (z-axis) (mm [in]): 1.94 [0.076]
• Contact Type: Socket
• Contact Base Material: Phosphor Bronze
• Contact Plating, Mating Area, Material: Gold
• Contact Plating, Mating Area, Thickness (µm [?in]): 0.76 [29.92]
• Contact Design: Formed Socket
• Mating Alignment: Without
• Ul Voltage Rating (vac): 250
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Operating Temperature (°c [°f]): -55 – +105 [-67 – +221]
• Applies To: Wire/Cable
• Accepts Wire Insulation Diameter, Range (mm [in]): 0.635 – 1.27 [0.025 – 0.050]
• Application Use: Wire-to-Board, Wire-to-Board / Wire-to-Wire, Wire-to-Wire
• Contact Transmits (typical Application): Signal (Data)/ Power
• Packaging Method: Reel
• For Use With: MR Miniature Rectangular Connectors

4.2.
If changes significantly affecting form, fit or function are made to the product or manufacturing process, product
assurance shall coordinate requalification testing, consisting of all or part of the original testing sequence as
determined by development/product, quality and reliability engineering.
4.3.
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures attributed to
equipment, test setup or operator deficiencies shall not disqualify the product. When product failure occurs,
corrective action shall be taken and samples resubmitted for qualification. Testing to confirm corrective action is
required before resubmittal.
4.4.
Applicable AMP quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing and this
specification.
Rev G
NOTE
Requalification Testing
Acceptance
Quality Conformance Inspection
(a)
(b)
A 1 foot minimum length of continuous lead for heat dissipation.
Termination resistance equals millivolts divided by test current less resistance of 6
inches of wire.
Termination Resistance Measurement Points
Figure 3
108-1022
5 of 7