121LHS15 Renesas Electronics America, 121LHS15 Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/5/560/renesas_electronics_america_sml.jpg)
121LHS15
Manufacturer Part Number
121LHS15
Description
Manufacturer
Renesas Electronics America
Datasheet
1.121LHS15.pdf
(24 pages)
Specifications of 121LHS15
Lead Free Status / Rohs Status
Supplier Unconfirmed
GENERAL CAUTIONS
(1) Caution when removing the module
(2) Cautions for handling the module
(3) Cautions about atmosphere
20
The figures and statements below are very important. Please be sure you understand their contents.
<1>
<1>
<2>
<3>
<4>
<5>
<6>
<7>
<8>
<9>
<10> Do not stress interface connectors. The module may malfunction due to a defective contact and be
<1>
<2>
<3>
<4>
Pick up the pouch only, when removing the module from a carrier box.
As electrostatic discharges may break the LCD module, handle the LCD module with care against
electrostatic discharges. Peel the protection sheet from the LCD panel surface as slowly as possible.
As the surface of the polarizer is very soft and easily scratched, use a soft dry cloth without chemicals for
cleaning.
Do not pull the interface connectors in or out while the LCD module is operating.
Put the module display side down on a flat horizontal plane.
Handle connectors and cables with care.
When the module is operating, do not lose the CLK, Hsync, or Vsync signal. If any one of these signals
is lost, the LCD panel would be damaged.
The torque on mounting screws should never exceed 0.294 N m (3 kgf cm).
Don’t push or rub the surface of an LCD module. If you do, scratches or rubbing marks may be left on
the surface of the module.
damaged. Pay close attention to handling and orientation when matching connections.
Dew-drop atmosphere must be avoided.
Do not store and/or operate the LCD module in a high-temperature and/or high-humidity atmosphere.
Storage in an anti-static pouch and at room temperature is recommended.
This module uses cold cathode fluorescent lamps. The lifetime of lamp is shortened if the module is
operated in a low-temperature environment.
Do not operate the LCD module in a high magnetic field.
CAUTION
CAUTION
Do not touch an inverter on which there is a caution label, while the LCD module is in operation, because of
dangerous high voltage.
This figure is a mark that you will get an electric shock if you make a mistake in operation.
This figure is a mark that you will get hurt if you make a mistake in opration.
As the LCD panel and backlight element are made from fragile glass material, impact and
pressure to the LCD module should be avoided.
This figure is a mark that you will get hurt and/or the module will be damaged if you make a
mistake in operation.
Data Sheet EN0510EJ1V1DS00
NL8060BC31-17