DS90LV047ATMTCX National Semiconductor, DS90LV047ATMTCX Datasheet - Page 11

• Manufacturer Part Number: DS90LV047ATMTCX
• Manufacturer: National Semiconductor

Specifications of DS90LV047ATMTCX

• Number Of Elements: 4
• Number Of Receivers: 4
• Number Of Drivers: 4
• Input Type: CMOS/TTL
• Operating Supply Voltage (typ): 3.3V
• Differential Output Voltage: 450mV
• Power Dissipation: 1.088W
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 16
• Package Type: TSSOP
• Lead Free Status / Rohs Status: Not Compliant

Typical Performance Curves
DATA RATE VS CABLE LENGTH GRAPH TEST PROCEDURE
A pseudo-random bit sequence (PRBS) of 2
programmed into a function generator (Tektronix HFS9009)
and connected to the driver inputs via 50Ω cables and SMB
connectors. An oscilloscope (Tektronix 11801B) was used to
probe the resulting eye pattern, measured differentially at the
input to the receiver. A 100Ω resistor was used to terminate
the pair at the far end of the cable. The measurements were
taken at the far end of the cable, at the receiver"s input, and
used for the jitter analysis for this graph. The frequency of
the input signal was increased until the measured jitter (t
equaled 20% with respect to the unit interval (t
particular cable length under test. Twenty percent jitter is a
reasonable place to start with many system designs. The
data used was NRZ. Jitter was measured at the 0V differen-
tial voltage of the differential eye pattern. The cables used
were LG UTP 4 pair 24 gauge CAT 5 cables. The
DS90LV047A and DS90LV048A were tested using the new
(Continued)
Cable Length
Data Rate vs
9
−1 bits was
10088730
tui
) for the
tcs
)
11
LVDS Flow-Evaluation Board LVDS47/48PCB which is avail-
able in the LVDS47/48EVK evaluation kit.
The curve shows very good typical performance that can be
used as a design guideline for data rate vs cable length.
Increasing the jitter percentage increases the curve respec-
tively, allowing the device to transmit faster over longer cable
lengths. This relaxes the jitter tolerance of the system allow-
ing more jitter into the system, which could reduce the reli-
ability and efficiency of the system. Alternatively, decreasing
the jitter percentage will have the opposite effect on the
system. The area under the curve is considered the safe
operating area based on the above signal quality criteria. For
more information on eye pattern testing, please see National
Application Note AN-808.
www.national.com