AM2LW-2405S-NZ Aimtec Inc., AM2LW-2405S-NZ Datasheet - Page 3

• Manufacturer Part Number: AM2LW-2405S-NZ
• Description: DC/DC 2 WATT
• Manufacturer: Aimtec Inc.

Recommended Filter Circuit
All the AM2LW-Z Series have been tested with the above recommended test circuit.
If it is necessary to further decrease the input/output ripple, the value of the filter capacitor can be increased; a capacitor with a low ESR
should be used. Excessive filter capacitance can cause start up problems with the converter.
In general, the recommended capacitance values are:
Cin: 10μF~47μF
Cout: 10μF/100mA
Refer to table below for maximum capacitor values:
External Capacitor Value
Derating
NOTE: 1.
by Aimtec; refer to www.aimtec.com for the most current product specifications.
date manufactured.
nominal input voltage and at rated output load unless otherwise specified.5..Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet.
www.aimtec.com
F 051e R8
+ Vin
Single Output
Vout (VDC)
- Vin
Cin
+
Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
12
15
5
3.
DC
Mechanical drawings and specifications are for reference only.
Cout (uF)
Dual Output
1000
470
330
DC
Dual Output
Vout (VDC)
Cout
Cout
±12
±15
±5
+
+
+Vout
Common
-Vout
Cout (uF)
Tel: [phone]
±680
±330
±220
2.
Product labels shown, including safety agency certifications on labels, may vary based on the
3 of 3
4.
+ Vin
All specifications are measured at an ambient temperature of 25°C, humidity<75%,
- Vin
Cin
+
This series should be tested under load.
DC
Single Output
Series AM2LW-NZ
1.5 Watt | DC-DC Converter
DC
Toll free: + 1 888 9 AIMTEC
Cout
+
North America only
- Vout
+Vout
5.
(924 6832)
This