SS1-IC Parallax Inc, SS1-IC Datasheet - Page 2
![MODULE SPIN STAMP MCU 24-DIP](/photos/6/75/67549/mfg_ss1-ic_sml.jpg)
SS1-IC
Manufacturer Part Number
SS1-IC
Description
MODULE SPIN STAMP MCU 24-DIP
Manufacturer
Parallax Inc
Datasheet
1.SS1-IC.pdf
(3 pages)
Specifications of SS1-IC
Module/board Type
Spin Stamp Module
Product
Microcontroller Basic Stamps
Data Bus Width
32 bit
Clock Speed
10 MHz
Operating Supply Voltage
5.5 V to 12 V
Board Size
31 mm x 16 mm
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
BASIC Stamp®
For Use With
28138 - BOARD DEV PROFESSIONAL
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
SS1-IC
Manufacturer:
Parallax
Quantity:
135
Mechanical Drawing and Pin Description
Copyright © Parallax Inc.
5-20
Pin
21
22
23
24
--
--
--
--
1
2
3
4
P0-P15
Name
SOUT
SIN
VDD
ATN
VSS
RES
VSS
RST
VSS
P30
P31
VIN
Connection details not available at this time.
Connection details not available at this time.
Connection details not available at this time.
System ground: (same as pin 23)
General-purpose I/O pins: each can source and sink 40 mA. However, the total of all pins should not
exceed 300 mA (source or sink).
5-volt DC input/output: if an unregulated voltage is applied to the VIN pin, then this pin will output 5
volts. If no voltage is applied to the VIN pin, then a regulated voltage between 4.5V and 5.5V should
be applied to this pin.
Reset input/output: goes low when power supply is less than approximately 4.2 volts, causing the Spin
Stamp to reset. Can be driven low to force a reset. This pin is internally pulled high and may be left
disconnected if not needed. Do not drive high.
System ground: (same as pin 4) connects to power supply’s ground (GND) terminal.
Unregulated power in: accepts 5.5 - 12 VDC (7.5 recommended), which is then internally regulated to
5 volts. Must be left unconnected if 5 volts is applied to the VDD (+5V) pin.
Propeller port pin P30
Propeller port pin P31
Propeller port pin RESn
System ground: (same as pin 23)
Spin Stamp (#SS1-IC)
Description
v1.0 04/2007 Page 2 of 3