DC-ME-Y402-LX Digi International, DC-ME-Y402-LX Datasheet - Page 38

• Manufacturer Part Number: DC-ME-Y402-LX
• Description: ME 9210 8MB RAM 4MB FLASH LINUX
• Manufacturer: Digi International
• Type: Network Controller & Processorr

Specifications of DC-ME-Y402-LX

• Module/board Type: Device Server
• Data Rate: 10 Mbps to 100 Mbps
• Memory Type: SDRAM
• Interface Type: Ethernet
• Operating Voltage: 3.3 V
• Operating Current: 346 mA
• Maximum Power Dissipation: 825 mW
• Operating Temperature Range: - 40 C to + 80 C
• Board Size: 36.7 mm x 19.05 mm
• Data Bus Width: 32 bit
• Modulation: CCK, DBPSK, DQPSK
• Product: Modules
• Security: 64/128 bit WEP, TKIP, WPA, WPA2
• For Use With/related Products: Networking
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant






Network Interface
Serial Interface
Standard: IEEE 802.3
Physical Layer: 10/100Base-T
Data Rate: 10/100Mbps (auto-sensing)
Mode: Half-duplex and full-duplex support
Connector: RJ-45
(auto-sensing)
Digi Connect ME/ME9210
One TTL serial interface (CMOS 3.3v) with full modem control signals (DTR, DSR, DCD,
RTS, CTS). The Connect ME 9210 also supports SPI and FIM-based application specific
interfaces.
Module Specifications
A
P
P
Caution: The Digi Connect ME and Digi Connect Wi-ME embedded
modules were designed for use in no clean flux wave soldering processes.
The product is not designed to support draining after a water-wash
process, which can lead to water residue inside the enclosure resulting
from direct entry or condensation after the wash process.
E
N
D
I
X







A
Standard: IEEE 802.11b
Frequency: 2.4 GHz
Data Rate: Up to 11 Mbps with automatic fallback
Modulation: CCK (11/5 Mbps), DQPSK (2 Mbps),
DBPSK (1 Mbps)
Transmit Power: 16 dBm typical
Receive sensitivity:
Antenna Connector: 1 x RP-SMA
–
–
–
–
1Mbps: -92 dBm
2Mbps: -89 dBm
5.5Mbps: -87 dBm
11Mbps: -82 dBm
Digi Connect Wi-ME
      
3 8