DC-ME4-01T-S-10 Digi International, DC-ME4-01T-S-10 Datasheet - Page 37

• Manufacturer Part Number: DC-ME4-01T-S-10
• Description: DIGI CONNECT 4MB FLASH 8MB RAM
• Manufacturer: Digi International

Specifications of DC-ME4-01T-S-10

• Module/board Type: Device Server
• For Use With/related Products: Networking
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q3648859

37
      
The following table illustrates typical power consumptions using these power management
mechanisms. These measurements were taken with all Digi NS9210 processor’s I/O clocks
disabled except UART A, UART C, Ethernet MAC, I/O Hub and Memory Clock0 with the
ethernet connected to a 100Mb network, using a standard module plugged into a Digi
JumpStart Kit development board, with nominal voltage applied:
Note 1: This measurement was taken from the R6 current sense resistor using a 0.025 ohm shunt on the
JumpStart Kit development board.
Note 2: This is the default power consumption mode when entering applicationStart(), as measured with the
napsave sample application. The value of the NS9210 Clock Configuration register (A090017C) is 0001200B
hexadecimal.
Note 3: This measurement was produced by selecting the “Clock Scale” menu option in the napsave sample
application.
Note 4: This measurement was produced by selecting the “Deep Sleep/Wakeup with an External IRA” menu
option in the napsave sample application.
Normal Operational Mode
Full Clock Scaling Mode
Sleep Mode
Mode
4
3
2
Power Consumption
1.14W (346mA)
.613W (186mA)
.113W (34mA)
1