MC7447AHX1000NB Freescale Semiconductor, MC7447AHX1000NB Datasheet - Page 10

• Manufacturer Part Number: MC7447AHX1000NB
• Description: IC MPU RISC 1000MHZ 360-FCCBGA
• Manufacturer: Freescale Semiconductor

Specifications of MC7447AHX1000NB

• Processor Type: MPC74xx PowerPC 32-Bit
• Speed: 1.0GHz
• Voltage: 1.1V
• Mounting Type: Surface Mount
• Package / Case: 360-FCCBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Features: -

Electrical and Thermal Characteristics
Figure 2
The MPC7447A provides several I/O voltages to support both compatibility with existing systems and
migration to future systems. The MPC7447A core voltage must always be provided at the nominal voltage
(see
input voltage threshold for each bus is selected by sampling the state of the voltage select pins at the
negation of the signal HRESET. The output voltage will swing from GND to the maximum voltage applied
to the OV
change in future products, it is recommended that BVSEL be configured using resistor options, jumpers,
or some other flexible means, with the capability to reconfigure the termination of this signal in the future
if necessary.
10
Storage temperature range
Notes:
1. Functional and tested operating conditions are given in
2. Caution: V
3. Caution: OV
4. BVSEL must be set to 0, such that the bus is in 1.8-V mode.
5. BVSEL must be set to HRESET or 1, such that the bus is in 2.5-V mode.
6. Caution: V in must not exceed OV
7. V
functional operation at the maximums is not guaranteed. Stresses beyond those listed may affect device reliability or cause
permanent damage to the device.
maximum of 20 ms during the power-on reset and power-down sequences.
maximum of 20 ms during the power-on reset and power-down sequences.
Table
in
may overshoot/undershoot to a voltage and for a maximum duration as shown in
shows the undershoot and overshoot voltage on the MPC7447A.
DD
4) or at the supported derated voltage (see
DD
power pins.
DD
/AV
must not exceed V
DD
must not exceed OV
MPC7447A RISC Microprocessor Hardware Specifications, Rev. 5
Table 3
OV
GND – 0.3 V
GND – 0.7 V
OV
Characteristic
DD
Table 2. Absolute Maximum Ratings
DD
+ 20%
DD
OV
+ 5%
DD
GND
Figure 2. Overshoot/Undershoot Voltage
provides the input threshold voltage settings. Because these settings may
V
V
by more than 0.3 V at any time including during power-on reset.
DD
/AV
IH
IL
DD
DD
by more than 1.0 V during normal operation; this limit may be exceeded for a
by more than 2.0 V during normal operation; this limit may be exceeded for a
Table
Section 5.3, “Voltage and Frequency
Not to Exceed 10%
4. Absolute maximum ratings are stress ratings only, and
of t
SYSCLK
1
(continued)
Symbol
T
stg
Figure
Maximum Value
2.
–55 to 150
Freescale Semiconductor
Derating”). The
Unit Notes
°C
—