SDV-SH5 Omron, SDV-SH5 Datasheet - Page 8
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
SDV-SH5
Manufacturer Part Number
SDV-SH5
Description
Sensor Hardware & Accessories SHUNT 5A
Manufacturer
Omron
Specifications of SDV-SH5
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
■ Setting
(Refer to Examples of Mode Settings for details on individual models.)
Set the desired values using the DIP switch and setting knobs on the front panel.
Opening the DIP Switch Cover
Remove the cover of the compartment containing the DIP switch for various mode settings, and then set the DIP switch according to the SWITCH
SELECTION table affixed to the side of the voltage sensor.
Setting the DIP Switch
Set the DIP switch on the front panel for the required functions, operation inputs, and voltages. Set the switch to the top for ON settings and to the
bottom for OFF settings.
• Function (SDV-F): Set to either overvoltage or undervoltage detection.
• Input: Set to either AC or DC input.
• Polarity (SDV-FL@ only): Set polarity or not to specify polarity.
• Multiplying Factor: Set the voltage scale multiplying factor for the required operating voltage setting range.
• TIMER (SDV-FH@T): Select the timing function.
Setting of Time (SDV-FH@T Only)
Use the time setting knob to set the desired time.
Closing the DIP Switch Cover
Attach the cover to the compartment housing the DIP switch. Select the stickers for the settings that have been made and attach them to the cover.
Setting Flowchart
Flat-blade
screwdriver
Set ON-delay, OFF-delay, lock timer (start lock timer), or TIMER OFF.
If TIMER OFF is set, the timing function will not be effective, and the single-function operation will be performed.
Determine detection method, polarity setting, operating value,
and reset value.
Obtain the PICK UP index scale value, HOLD index scale
value, and voltage multiplying factor.
Set the knob and the DIP switch, and attach stickers.
Set the desired operating mode for the SDV-FH@T.
Cover
Single-function Model
“8(+), 7(–)”: Use polarity as shown for pin number.
“FREE”:
Do not use polarity.
Select model based on operation and type of input.
Determine intermediate voltage of dead band and dead band
voltage.
Determine reset value according to dead band voltage.
Obtain the BALANCE index scale value, BAND WIDTH index
scale value, and voltage multiplying factor.
Set the knob and the DIP switch, and attach stickers.
Cover
Flat-blade screwdriver
Dual-function Model
SDV
8