CS42436-CMZ Cirrus Logic Inc, CS42436-CMZ Datasheet - Page 51

• Manufacturer Part Number: CS42436-CMZ
• Description: IC CODEC 108DB 192KHZ 52-MQFP
• Manufacturer: Cirrus Logic Inc
• Type: Audio Codecr

Specifications of CS42436-CMZ

• Package / Case: 52-MQFP, 52-PQFP
• Data Interface: Serial
• Resolution (bits): 24 b
• Number Of Adcs / Dacs: 6 / 6
• Sigma Delta: Yes
• Dynamic Range, Adcs / Dacs (db) Typ: 105 / 108 (Differential), 102 / 105 (Single-Ended)
• Voltage - Supply, Analog: 3.14 V ~ 5.25 V
• Voltage - Supply, Digital: 3.14 V ~ 3.47 V
• Operating Temperature: -10°C ~ 70°C
• Mounting Type: Surface Mount
• Number Of Adc Inputs: 6
• Number Of Dac Outputs: 6
• Conversion Rate: 192 KSPS
• Interface Type: Serial (I2C, SPI)
• Resolution: 24 bit
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 10 C
• Number Of Channels: 6 ADC/6 DAC
• Thd Plus Noise: - 98 dB ADC / - 98 dB DAC, - 95 dB ADC / - 95 dB DAC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 598-1612

DS647F2
8.1.1
8.1.2
Passive Input Filter
The passive filter implementation shown in
will not provide optimum source impedance for the ADC modulators. Full analog performance will there-
fore not be realized using a passive filter.
In this topology the distortion performance is affected, but the dynamic range performance is not limited.
Passive Input Filter w/Attenuation
Some applications may require signal attenuation prior to the ADC. The full-scale input voltage will scale
with the analog power supply voltage. For VA = 5.0 V, the full-scale input voltage is approximately
2.8 Vpp, or 1 Vrms (most consumer audio line-level outputs range from 1.5 to 2 Vrms).
Figure 23
pedance on the analog inputs, the full distortion performance cannot be realized. Also, the resistor divider
circuit will determine the input impedance into the input filter. In the circuit shown in
impedance is approximately 5 kΩ. By doubling the resistor values, the input impedance will increase to
10 kΩ. However, in this case the distortion performance will drop due to the increase in series resistance
on the analog inputs.
shows a passive input filter with 6 dB of signal attenuation. Due to the relatively high input im-
100 kΩ
100 kΩ
100 kΩ
Figure 22. Passive Input Filter
150 Ω
150 Ω
150 Ω
10 μF
10 μF
10 μF
Figure 22
Figure 22
4.7 μF
illustrates the unity gain, passive input filter solution.
2700 pF
2700 pF
2700 pF
C0G
C0G
C0G
will attenuate any noise energy at 6.144 MHz but
AIN1+,2+,3+,4+
AIN1-,2-,3-,4-
AIN5A,6A
AIN5B,6B
ADC1-2
ADC3
Figure
CS42436
23, the input
51