RSP-1000-15 Mean Well, RSP-1000-15 Datasheet - Page 3

Linear & Switching Power Supplies 750W 15V 50A W/PFC

RSP-1000-15

Manufacturer Part Number
RSP-1000-15
Description
Linear & Switching Power Supplies 750W 15V 50A W/PFC
Manufacturer
Mean Well
Datasheet

Specifications of RSP-1000-15

Lead Free Status / Rohs Status
Lead free / RoHS Compliant
1."Remote ON/OFF" and "Output voltage trim" functions are not used.
Function Description of CN50
Function Manual
The power supply unit will have no output if the shorting connector (accessory comes along with the PSU) is not assembled. It contains
two shorting wires : one is from ON/OFF (pin6) to -S (pin2) and the other is from Vco (pin8) to Vca (pin10).
Pin No. Function Description
11,12
10
1
2
3
4
5
6
7
8
9
5V-AUX
ON/OFF
DC_OK
G-AUX
GND
Vco
Vca
CS
+S
Vci
-S
1000W Single Output Power Supply
Positive sensing. The +S signal should be connected to the positive terminal of the load. The +S and -S leads should be twisted in pair to
minimize noise pick-up effect. The maximum line drop compensation is 0.5V.
Negative sensing. The -S signal should be connected to the negative terminal of the load. The -S and +S leads should be twisted in pair to
minimize noise pick-up effect. The maximum line drop compensation is 0.5V.
Auxiliary voltage output ground. The signal return is isolated from the output terminals (+V & -V).
Auxiliary voltage output, 4.6~5.25V, referenced to pin 3(G-AUX). The maximum load current is 0.5A. This output has the built-in oring
diodes and is not controlled by the "remote ON/OFF control".
Open collector signal, referenced to pin11,12(GND). Low when PSU turns on. The maximum sink current is 10mA and the maximum
external voltage is 5.6V.
Turns the output on and off by electrical or dry contact between pin 6 ( ON/OFF) and pin 2 (-S). Short: Power ON, Open: Power OFF.
Current sharing signal. When units are connected in parallel, the CS pins of the units should be connected to allow current balance
between units.
Short connecting between Vco (pin8) and Vca (pin10) if output voltage trim function is not used.
Connect to external DC voltage source for output voltage triming, referenced to pin 2 (-S). Output voltage can be trimmed between
40 ~ 110% of the rated output voltage.
Connect to external resistor (1/8W) for output voltage triming. Output voltage can be trimmed between 40 ~ 110% of the rated output
voltage. Please refer to function manual for details.
These pins connect to the negative terminal (-V). Return for DC_OK Signal output.
+V
+
LOAD
-
-V
SVR51 CN50
Fig 1.1
1 11
2 12
TB1
2
+S
-S
1
AUXG
(Shorting connector)
AUX
DC_OK
ON/OFF
R S P - 1 0 0 0
CN50
Vco
CS
Vca
Vci
GND
GND
12
11
File Name:RSP-1000-SPEC 2011-02-17
s e r i e s

Related parts for RSP-1000-15