DP83850CVF National Semiconductor, DP83850CVF Datasheet - Page 13
![no-image](/images/manufacturer_photos/0/4/469/national_semiconductor_sml.jpg)
DP83850CVF
Manufacturer Part Number
DP83850CVF
Description
IC CONTROLLER INTERFACE 132-PQFP
Manufacturer
National Semiconductor
Datasheet
1.DP83850CVF.pdf
(37 pages)
Specifications of DP83850CVF
Controller Type
Ethernet Repeater Interface Controller
Interface
Serial
Voltage - Supply
4.75 V ~ 5.25 V
Current - Supply
295mA
Operating Temperature
0°C ~ 70°C
Mounting Type
Surface Mount
Package / Case
132-MQFP, 132-PQFP
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Other names
*DP83850CVF
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
DP83850CVF
Manufacturer:
Texas Instruments
Quantity:
10 000
Part Number:
DP83850CVF
Manufacturer:
NS/国半
Quantity:
20 000
3.0 Functional Description
(Continued)
Subsequently writing 0000h to the PAGE register in Regis-
ter Page 1 switches the registers back to Register Page 0.
All accesses to DP83850C registers and counters, and to
the connected Physical Layer devices (via the DP83850C),
are performed serially using the RDIO and RDC pins. The
RDC clock is limited to a frequency no greater than
2.5MHz. This interface implements the serial management
protocol defined by the MII specification, IEEE 802.3u
clause 22. The protocol uses bit streams with the following
format:
For Read operation: <start><opcode><device addr><reg
addr> [turnaround] 0<data>.
For Write operation: <start><opcode><device addr><reg
addr> <10><data>.
This protocol allows for up to 32 devices (DP83850Cs or
other MII compliant devices) to be connected, each with a
unique address and up to 32 16-bit registers. Devices are
cascaded on the RDIO and RDC signals.
Since the RDIO pin is shared for both read and write oper-
ations, it must only be driven at the proper time. The serial
protocol assumes that there is only one master (generally,
the management entity's processor) and one or more slave
devices (generally, the Physical Layer or DP83850C chips).
The master drives RDIO at all times except when, during a
slave read operation, the addressed slave places the seri-
alized read data onto the RDIO line after the line turn-
around field's first bit.
For unmanaged systems that do not use the DP83856
100RIB device for repeater management, it is important to
provide the 100RIC with a minimum of 3 cycles of RDC
during device reset. If the minimum number of cycles of
RDC is not provided, the Serial Register Access Logic
block may not be properly reset and as a result RDIO may
not function properly. The 100RIB provides continuous
RDC cycles, and eliminates this concern.
The fields of the protocol are defined in Table 3-1. In order
for the protocol to work, all serial logic must first be “syn-
chronized” to incoming data. A preamble of 32 consecutive
1's transmitted before the <start> field ensures "data lock".
13
www.national.com