31-15 (UG-261/U) AMPHENOL RF, 31-15 (UG-261/U) Datasheet - Page 8

• Manufacturer Part Number: 31-15 (UG-261/U)
• Description: connector, rf coaxial, bnc str jack, clamp/solder, for rg59, 62, 71, 140, 210 cable
• Manufacturer: AMPHENOL RF
• Type: Cable Jackr

Specifications of 31-15 (UG-261/U)

• Angle: Straight
• Application: True MIL
• Cable Type: RG/U 140,59,62,71,140,210
• Contact Plating: Silver
• Finish, Housing: Nickel
• Gender: Jack
• Impedance: 50 Ohms
• Material, Contact: Brass (Male), Beryllium Copper⁄Phosphor Bronze (Female)
• Material, Dielectric: TFE/Styrene
• Material, Housing: Brass
• Mating Type: Bayonet
• Primary Type: BNC
• Temperature, Operating: -65 to +165 °C
• Termination: Solder
• Voltage, Rating: 500 V
• Lead Free Status / Rohs Status: RoHS Compliant part

Assembly Instructions-C30
BNC
PLUGS FCP TERMINATION
Step 1
Step 2
Step 3
Step 4
Amphenol Corporation Tel: [phone]
outer ferrule
31-4700
31-4702
Amphenol
Number
.250(6.4)
.156(4.0)
contact
center
BNC Plug
BNC Plug
Connector
Type
305
Step 1 Slide ferrule over cable end, slotted end first. Strip cable to
Step 2 Tin exposed center conductor. Solder center contact on
Step 3 Slide body over contact and cable insulation with barb going
Step 4 Grasp cable with hand and push ferrule over barb until braid
dimensions shown. Do not nick center conductor. Flare
braid slightly as shown.
center conductor. Use minimum heat to avoid damaging
cable insulation. Remove any excess solder and flux from
contact surface. Contact may be crimped using
227-1221-11 die set (cavity B) .068 hex in tool handle
227-944 or equivalent tool.
UNDER flared braid. Push body until shoulder is against
cable jacket. Braid will flare out against body shoulder.
is captured between ferrule and body flange. Assembly is
complete.
58, 141
59
RG-/U
Cable
plug body assembly
Amphenol
www.amphenolrf.com
®