XN4E-BL422MR IDEC Corporation, XN4E-BL422MR Datasheet - Page 6

• Manufacturer Part Number: XN4E-BL422MR
• Description: Switch, E-Stop, Padlock, 30MM Mushroom
• Manufacturer: IDEC Corporation

342
Screw Terminal Type
1. Wire thickness: 0.75 to 1.25 mm
Be sure to install an insulating tube on the crimping terminal.
2. Tighten the M3 terminal screw to a tightening torque of 0.6 to 1.0 N·m.
Connector Type
1. Connector shape
2. Applicable connectors (to be supplied by user)
3. To prepare correct receptacles for the connector type, read the instruction
4. Fasten the cable so that the connector is not pulled.
Installing and Removing Terminal Covers
XW9Z-VL2M
To install the terminal cover, align the TOP marking on the terminal cover with
the TOP marking on the contact block. Place the two projections on the bottom
side of the contact block into the slots in the terminal cover. Press the terminal
cover toward the contact block.
Tyco Electronics, D-2000 series
Part No. 1376009-1 (tab header, board mount)
Tyco Electronics, D-2000 series
Part No. 1-1318119-4 (receptacle housing)
Tyco Electronics, D-2000 series
Part No. 1318107-1 (receptacle contact)
sheet and catalog of Tyco Electronics and understand the installation and
wiring method.
Otherwise the switch may be deformed and damaged, causing malfunction or
operation failure.
Applicable Crimping Terminals
Crimping
Terminal
j Place the projections
Ring Terminal
on the contact block
ø3.2 min.
4.7 to 5.9
4.7 min.
Insulating Tube
XN Series
Wire
3.0 max.
2
Spade Terminal
(AWG18 to 16)
Crimping Terminal
4.7 to 5.9
4.7 to 5.9
Insulating Tube
TOP marking
k Press the
Wire
Operating Instructions, continued
terminal cover
Solid Wire
6.2 max.
www.idec.com
To remove the terminal cover, pull out the two latches on the top side of the
terminal cover. Do not exert excessive force to the latches, otherwise the latches
may break.
IP20 Protection Terminal Cover
XW9Z-VL2MF
To install the IP20 protection cover, align the TOP marking on the cover with the
TOP marking on the contact block, and press the cover toward the contact block.
Contact Bounce
When the button is reset by pulling or turning, the NC main contacts will bounce.
When pressing the button, the NO monitor contacts will bounce.
When designing a control circuit, take the contact bounce time into consider-
ation (reference value: 20 ms).
LED Illuminated Switches
An LED lamp is built into the contact block and cannot be replaced.
Installing the Anti-rotation Ring
HW9Z-RL
Align the side without thread on the operator with TOP marking, the small s
marking on the anti-rotation ring, and the recess on the mounting panel.
Anti-rotation Ring (HW9Z-RL)
1. Once installed, the XW9Z-VL2MF cannot be removed.
2. The XW9Z-VL2MF cannot be installed after wiring.
3. With the XW9Z-VL2MF installed, crimping terminals cannot be used. Use solid wires.
4. Make sure that the XW9Z-VL2MF is securely installed. IP20 cannot be achieved when
TOP marking
installed loosely, and electric shocks may occur.
Without thread
TOP Markings
p marking on the anti-rotation ring
(Press)
Pull out the latches
X Series E-Stops
TOP marking
TOP marking