NJM3774FM2-TE2 NJR, NJM3774FM2-TE2 Datasheet - Page 8
![Motor / Motion / Ignition Controllers & Drivers Dual Stepper](/photos/36/39/363951/plcc28_sml.jpg)
NJM3774FM2-TE2
Manufacturer Part Number
NJM3774FM2-TE2
Description
Motor / Motion / Ignition Controllers & Drivers Dual Stepper
Manufacturer
NJR
Type
Stepper Motor Controller/Driverr
Datasheet
1.NJM3774FM2.pdf
(9 pages)
Specifications of NJM3774FM2-TE2
Product
Stepper Motor Controllers / Drivers
Operating Supply Voltage
10 V to 45 V
Supply Current
60 mA to 75 mA
Mounting Style
SMD/SMT
Package / Case
PLCC-28
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Programming
Figure 8 shows the different input and output sequences for full-step, half-step and modified halfstep operations.
Full-step mode
Both windings are energized at all the time with the same current, I
current direction (and the magnetic field direction) in one phase is reversed. The next step is then taken when the
other phase current reverses. The current changes go through a sequence of four different states which equal four
full steps until the initial state is reached again.
Half-step mode
In the half-step mode, the current in one winding is brought to zero before a complete current reversal is made. The
motor will then have taken two half steps equalling one full step in rotary movement. The cycle is repeated, but on
the other phase. A total of eight states are sequenced until the initial state is reached again.
one or more distinct stepping rates and must be avoided so as not to loose control of the motor´s shaft position.
through one winding only. The torque in this position is approximately 70 % of the full step position torque.
Modified half-step mode.
The torque variations in half step mode will be elimi-nated if the current is increased about 1.4 times in the halfstep
position. A constant torque will further reduce resonances and mechanical noise, resulting in better performance,
life expectancy and reliability of the mechanical system.
correspondingly. This can be done by using DACs or simple resistor divider networks, as shown in figure 9.
mA per winding in the full-step position, and 1000 mA in the half-step position.
Half-step mode can overcome potential resonance problems. Resonances appear as a sudden loss of torque at
One disadvantage with the half-step mode is the reduced torque in the half step positions, in which current flows
Modifying the current levels must be done by bringing the reference voltage up (or down) from its nominal value
The NJM3774 is designed to handle about 1.4 times higher current in one channel on mode, for example 700
Figure 9. Reduction of reference
voltage at the V
70 % current
V
GND
+5 V
level
Ref
10 k
1.2 k
R
pin of NJM3774
2.2 k
1.2 k
M1
10 nF
= I
V
V
NJM3774
R1
R2
M2
and
on
. To make the motor take one step, the
NJM3774