WLNG-EK-DP551 Quatech, WLNG-EK-DP551 Datasheet - Page 3

• Manufacturer Part Number: WLNG-EK-DP551
• Description: WiFi / 802.11 Modules & Development Tools AIRBORNE EVAL KIT EMBEDDED MODULES
• Manufacturer: Quatech
• Series: Airborne™r
• Type: Transceiver, 802.11 b/gr

Specifications of WLNG-EK-DP551

• Mfg Application Notes: Transition to DP550 Devices AppNote
• Frequency: 2.4GHz ~ 2.4835GHz
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Airborne Modules

Quatech, Inc
Serial Device Server Connection
If you have purchased the WLNG-EK-DP501 or WLNG-EK-DP502 kit please use the following
instructions for connecting to and evaluating the Airborne Serial Device Server. The following
describes initial connection to an Airborne Device Server module loaded with serial firmware, if
you have a module loaded with Ethernet firmware, please skip to Page 6.
1.
2.
100-8002-110
Connect a Host Computer
Use the supplied serial cable or USB adapter (see USB-to-Serial Adapter User’s Manual
for USB adapter installation) to connect the DB9 serial port (CN1) connector on the
Airborne EVB to the Host computer. On the Host computer, start a terminal emulation
program such as HyperTerminal. Configure the program for 9600 baud, 8 data bits, no
parity, and no flow control. For COM Port, select the COM port that corresponds to the
host’s physical serial port connected to the EVB (or in the case of the USB adapter, the
virtual COM port created by the adapter software)
Interacting with the Airborne™ Module
On the Host computer, use the terminal emulation program to interact with the module
by issuing Command Line Interface (CLI) commands. CLI commands let you request
status or change parameter settings. Press the Enter key (<CR>) after each command
line you type. After the module starts, type the following CLI command to log in (you
must log in before CLI commands can be recognized):
CLI Command
auth dpac dpac <CR>

You will have to log into the module after any reset or restart.
3
Description
The module responds with OK, indicating that it
executed the command successfully. (If you did
not receive OK, check the settings in your
terminal emulation program.
Enterprise Eval Kit Quick Start Guide
Connect with Reliability